Precor 9.33, 9.31 manual 3x Low-Impact Treadmills Assembly Guide

Position the display console so the half-round cutout rests on the display support bar. Place any excess cables inside the display console. Tip the display console up so its base aligns with the mounting bracket on the center handrail.

CAUTION: Have your assistant hold the display console until it is fastened to the center handrail and display support bar. If it drops, cables will stretch or break and damage will occur to the electronic boards. The Precor Limited Warranty does not cover damage caused during installation.

Secure the display console to the display support bar with two socket head screws (E). Wrench tighten using a ³⁄₁₆-inch hex key.

Once the display console is secure, your assistant can stop supporting it.

Secure the display console to the center handrail with one socket head screw (C). Wrench tighten using the ³⁄₁₆-inch hex key.

Attach the console cover (G) by inserting the bottom two tabs. Rotate the cover up and apply pressure so the top tab snaps into place.

Note: If you need to remove the cover, apply pressure to the thumb tab and rotate the cover out.

Place the two water bottle holders (J) onto their brackets and secure each with a buttonhead screw (F). Tighten each screw with a Phillips-head screwdriver.

Place the magnetic safety key (H) into the cutout on the display console.

9.3x Low-Impact Treadmills Assembly Guide 6