Precor 9.31, 9.33 manual Center handrail Display support bar

Center handrail

Display support bar

Position the hood over the running belt so you can slide it through the upright supports from the rear. Align the hood with its four fasteners. Use the ³⁄₁₆-inch hex key to wrench tighten the two side fasteners before wrench tightening the two fasteners that secure the front of the hood.

Install the display console.

a.Cut the wire ties that secure the cables to the center handrail and display support bar.

b.Ask your assistant to stand on the running belt and hold the display console. The display label must face the rear of the treadmill. Tilt the display console so the cables are easily accessible.

c.Stand to the side of the treadmill and connect each cable to its appropriate receptacle.

Note: The 9.31 has one cable connection. The 9.33 and 9.35 have two cable connections.

9.3x Low-Impact Treadmills Assembly Guide 5