Alliance Laundry Systems PHM798N, PHM802N manual VARIABLE-SPEED Model Front of Machine

Page 35

Specifications and Dimensions

0.75 in.	0.75 in.
(19 mm)	(19 mm)
34.125 in.
(867 mm)
	4.8125 in.
	(122 mm)
	9 in.
44.8125 in.	(229 mm)
(1138 mm)
39.25 in.	36 in.	(914mm)
(997 mm)	10.75 in.
1.25 in.	(273 mm)
1.25 in.
(32 mm)	1.25 in.
	(32 mm)
34.5625 in.
(878 mm)
	10.6875 in.
	(271 mm)
2 in.	2 in.
(51 mm)	(51 mm)
31.625 in.
(803 mm)
	0.75 in.
35.625 in.	(19 mm)
35.625 in.
(905 mm)
60 VARIABLE-SPEED MODEL
FRONT OF MACHINE	PHM631N
	PHM631N

Figure 13

F8138601

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

33

Image 35

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Operator Safety Machine Location Safe Operating EnvironmentEnvironmental Conditions AC Inverter Drive Input and Output ServicesModel Identification IntroductionName plate Location Replacement PartsCustomer Service Delivery InspectionModel Number Familiarization Guide Models Starting 4/1/09 0001Drive Train Information Weight And Shipping InformationWash Cylinder Information Door Opening InformationElectrical Heating Optional Balance DetectionDirect Steam Heating Optional Overall width, in. mm MED Uwtv Models Through 3/31/09 Machine DimensionsSpecifications and Dimensions Crush hazardUW35TV UW125TV Models UW150TV Models Dimension 35 125 Models Models UW Design 3 Models starting 10/4/10 Refer to and Figure Base BA Base Overall PHM807N Machine Foundation Requirements Proceed to Machine Mounting and Grouting section Concrete Foundation Pad InstallationLength for ONE Machine Floor Load Data 1272 1442 Speed 1745 2392 Speed 1797 2342 10.4 Mounting Bolt Installation Requirements Machine Mounting and Grouting Speed Models only Mounting Bolt Hole LocationsVARIABLE-SPEED Model Front of Machine 80 / 100 Models 1181 mm 178 mm 254 mm Model 35 2-SPEED Model Grout PlacementFor UniLinc Models, Navigate to the Inputs Outputs Menu Gap Setting for Vibration SwitchPound Model 60, 80, 100 and 125 Pound Models Design 1 150 Pound Model Drain Connection Requirements Drain Trough ConfigurationDrain Information Specifications 100 125 150 Water Connection Water Supply Information Specifications 80/100 125/150Air Cushions Risers 50Hz Conversion Electrical Installation RequirementsDo not use a phase adder on any variable- speed machine Specifications and Dimensions Cycle CodeM30 Control Models only Steam Supply Information 100 125/150 Steam Requirements Steam Heat Option OnlyChemical Injection Supply System Chemical Injection Supply System Connecting External Liquid Supplies to the Washer-ExtractorPHM553N External Supplies Chemical Injection Using Internal 24VAC Control Transformer Chemical injection Using External AC Power Source External Supply Signals ES1 Power supply Supply 1 Signal K1 Contact