Alliance Laundry Systems PHM802N, PHM798N manual Model

Page 38

Specifications and Dimensions

		10.375 in.	48.125 in.
		(264 mm)	48.125 in.
		(264 mm)	(1223 mm)
			(1223 mm)
in. mm)			51.375 in.
56	(1422	10.375 in.	51.375 in.
		10.375 in.	(1305 mm)
		(264 mm)
	47.875 in.	(1216 mm)	57.4 in.
			57.4 in.
			(1457 mm)
		12.125 in.
		(308 mm)
		15 in.	67.1 in.
		15 in.	(1704 mm)
		(381 mm)	(1704 mm)
		(381 mm)
		4 in.
		(102 mm)
		1.5 in.		1.5 in.
		(38.1 mm)		(38.1 mm)
			47 in.
			(1193 mm)
			50 in.
			(1270 mm)
			150 MODEL	PHM778N
			FRONT OF MACHINE	PHM778N
			FRONT OF MACHINE
				PHM778N

Figure 16

36

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F8138601

Image 38

Contents Washer-Extractors Page Contents Explanation of Safety Messages Important Safety InstructionsSafety Information Safety Decals Operator Safety Machine Location Safe Operating EnvironmentEnvironmental Conditions Input and Output Services AC Inverter DriveIntroduction Model IdentificationDelivery Inspection Replacement PartsCustomer Service Name plate Location0001 Model Number Familiarization Guide Models Starting 4/1/09Door Opening Information Weight And Shipping InformationWash Cylinder Information Drive Train InformationElectrical Heating Optional Balance DetectionDirect Steam Heating Optional Overall width, in. mm MED Crush hazard Machine DimensionsSpecifications and Dimensions Uwtv Models Through 3/31/09UW35TV UW125TV Models UW150TV Models Dimension 35 125 Models Models UW Design 3 Models starting 10/4/10 Refer to and Figure Base BA Base Overall PHM807N Machine Foundation Requirements Concrete Foundation Pad Installation Proceed to Machine Mounting and Grouting sectionLength for ONE Machine Floor Load Data 1272 1442 Speed 1745 2392 Speed 1797 2342 10.4 Mounting Bolt Installation Requirements Machine Mounting and Grouting Mounting Bolt Hole Locations Speed Models onlyVARIABLE-SPEED Model Front of Machine 80 / 100 Models 1181 mm 178 mm 254 mm Model Grout Placement 35 2-SPEED ModelGap Setting for Vibration Switch For UniLinc Models, Navigate to the Inputs Outputs MenuPound Model 60, 80, 100 and 125 Pound Models Design 1 150 Pound Model Drain Trough Configuration Drain Connection RequirementsDrain Information Specifications 100 125 150 Water Supply Information Specifications 80/100 125/150 Water ConnectionAir Cushions Risers Electrical Installation Requirements 50Hz ConversionDo not use a phase adder on any variable- speed machine Specifications and Dimensions Code CycleM30 Control Models only Steam Requirements Steam Heat Option Only Steam Supply Information 100 125/150Chemical Injection Supply System Connecting External Liquid Supplies to the Washer-Extractor Chemical Injection Supply SystemPHM553N External Supplies Chemical Injection Using Internal 24VAC Control Transformer Chemical injection Using External AC Power Source External Supply Signals ES1 Power supply Supply 1 Signal K1 Contact