Alliance Laundry Systems PHM798N, PHM802N manual 1181 mm 178 mm 254 mm

Page 37

Specifications and Dimensions

	0.75 in.		0.75 in.
	(19 mm)		(19 mm)
		46.5 in.
		(1181 mm)
			7 in.
			(178 mm)
			10 in.
			(254 mm)
		61.5 in.
		(1562 mm)
in. mm)			15 in.
in. mm)		55.47 in.	(381 mm)
48	(1219	55.47 in.
		(1409 mm)

		48.94 in.
		(1243 mm)
			15.25 in.
			(387 mm)
	23.25 in.		23.25 in.
	(591 mm)		(591 mm)
		48 in.
		(1219 mm)
			0.75 in.
			(19 mm)
		125 MODEL
		FRONT OF MACHINE	PHM633N
		FRONT OF MACHINE
			PHM633N

Figure 15

F8138601

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

35

Image 37

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Operator Safety Environmental Conditions Safe Operating EnvironmentMachine Location AC Inverter Drive Input and Output ServicesModel Identification IntroductionCustomer Service Replacement PartsDelivery Inspection Name plate LocationModel Number Familiarization Guide Models Starting 4/1/09 0001Wash Cylinder Information Weight And Shipping InformationDoor Opening Information Drive Train InformationDirect Steam Heating Optional Balance DetectionElectrical Heating Optional Overall width, in. mm MED Specifications and Dimensions Machine DimensionsCrush hazard Uwtv Models Through 3/31/09UW35TV UW125TV Models UW150TV Models Dimension 35 125 Models Models UW Design 3 Models starting 10/4/10 Refer to and Figure Base BA Base Overall PHM807N Machine Foundation Requirements Proceed to Machine Mounting and Grouting section Concrete Foundation Pad InstallationLength for ONE Machine Floor Load Data 1272 1442 Speed 1745 2392 Speed 1797 2342 10.4 Mounting Bolt Installation Requirements Machine Mounting and Grouting Speed Models only Mounting Bolt Hole LocationsVARIABLE-SPEED Model Front of Machine 80 / 100 Models 1181 mm 178 mm 254 mm Model 35 2-SPEED Model Grout PlacementFor UniLinc Models, Navigate to the Inputs Outputs Menu Gap Setting for Vibration SwitchPound Model 60, 80, 100 and 125 Pound Models Design 1 150 Pound Model Drain Connection Requirements Drain Trough ConfigurationDrain Information Specifications 100 125 150 Water Connection Water Supply Information Specifications 80/100 125/150Air Cushions Risers 50Hz Conversion Electrical Installation RequirementsDo not use a phase adder on any variable- speed machine Specifications and Dimensions Cycle CodeM30 Control Models only Steam Supply Information 100 125/150 Steam Requirements Steam Heat Option OnlyChemical Injection Supply System Chemical Injection Supply System Connecting External Liquid Supplies to the Washer-ExtractorPHM553N External Supplies Chemical Injection Using Internal 24VAC Control Transformer Chemical injection Using External AC Power Source External Supply Signals ES1 Power supply Supply 1 Signal K1 Contact