Alliance Laundry Systems PHM802N, PHM798N manual Chemical Injection Supply System

Page 54

Specifications and Dimensions

 

Chemical Injection Supply System

Undiluted chemical dripping can damage the washer-

 

 

 

 

extractor. Therefore, all chemical supply dispenser

 

 

 

WARNING

pumps should be mounted below the washer’s

 

 

 

injection point. All dispenser tubing should also run

Wear eye and hand protection when

below the injection point. Loops do not prevent drips

handling chemicals; always avoid direct

if these instructions are not followed. Failure to follow

contact with raw chemicals. Read the

these instructions could damage the machine and void

manufacturer’s directions for accidental

the warranty. Figure 27 shows a typical Chemical

contact before handling chemicals.

Injection Supply System.

Ensure an eye-rinse facility and an

 

emergency shower are within easy reach.

 

Check at regular intervals for chemical

 

leaks.

 

 

 

SW016

 

 

2

 

3

 

 

 

 

1

 

 

 

4

 

 

 

 

 

PHM825N

1

Injection Point

3

Chemical Dispenser Pump Outlet

2

Loops

4

PVC Pipe

Figure 27

52

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F8138601

Page 53 Page 55
Image 54
Page 53 Page 55
Contents Washer-Extractors Page Contents Explanation of Safety Messages Important Safety InstructionsSafety Information Safety Decals Operator Safety Safe Operating Environment Environmental ConditionsMachine Location Input and Output Services AC Inverter DriveIntroduction Model IdentificationDelivery Inspection Replacement PartsCustomer Service Name plate Location0001 Model Number Familiarization Guide Models Starting 4/1/09Door Opening Information Weight And Shipping InformationWash Cylinder Information Drive Train InformationBalance Detection Direct Steam Heating OptionalElectrical Heating Optional Overall width, in. mm MED Crush hazard Machine DimensionsSpecifications and Dimensions Uwtv Models Through 3/31/09UW35TV UW125TV Models UW150TV Models Dimension 35 125 Models Models UW Design 3 Models starting 10/4/10 Refer to and Figure Base BA Base Overall PHM807N Machine Foundation Requirements Concrete Foundation Pad Installation Proceed to Machine Mounting and Grouting sectionLength for ONE Machine Floor Load Data 1272 1442 Speed 1745 2392 Speed 1797 2342 10.4 Mounting Bolt Installation Requirements Machine Mounting and Grouting Mounting Bolt Hole Locations Speed Models onlyVARIABLE-SPEED Model Front of Machine 80 / 100 Models 1181 mm 178 mm 254 mm Model Grout Placement 35 2-SPEED ModelGap Setting for Vibration Switch For UniLinc Models, Navigate to the Inputs Outputs MenuPound Model 60, 80, 100 and 125 Pound Models Design 1 150 Pound Model Drain Trough Configuration Drain Connection RequirementsDrain Information Specifications 100 125 150 Water Supply Information Specifications 80/100 125/150 Water ConnectionAir Cushions Risers Electrical Installation Requirements 50Hz ConversionDo not use a phase adder on any variable- speed machine Specifications and Dimensions Code CycleM30 Control Models only Steam Requirements Steam Heat Option Only Steam Supply Information 100 125/150Chemical Injection Supply System Connecting External Liquid Supplies to the Washer-Extractor Chemical Injection Supply SystemPHM553N External Supplies Chemical Injection Using Internal 24VAC Control Transformer Chemical injection Using External AC Power Source External Supply Signals ES1 Power supply Supply 1 Signal K1 Contact
Top Page Image Contents