Programming Control
Manual Mode Flowchart
Enter Manual Mode.
Press and hold both #4 keypad and
#1 keypad at the same time.
“rAPd” - Quickly advance through active
cycles.
1. Press START (enter) keypad to begin Rapid Advance cycle and advance through cycle steps.
“Prog” - Program cycle information and other
features into the control.
1. Refer to the Manual Programming flowchart.
“AUdt” - Retrieve audit information for
machine.
1. Press START (enter) keypad.
“rSEt” - Reset the control’s programming data
to factory default.
1. Press START (enter) keypad.
“dIAg” - Run diagnostic tests on machine
operations.
1.Press START (enter) keypad. Refer to Diagnostic Tests flowchart.
* Option available on software version 2 only.
“CyC” - Total number of machine cycles: 1. Press START (enter) once to read audit.
“rCyC” * - Total number of rapid advance cycles:
1. Press START (enter) once to read audit.
PHM140
PHM1401R
Figure 2
14 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F8208801 |