6.IR Access (On/Off) “IrA”
This option allows the owner to enable or disable allowing the control to be read by an external device.
How to Program the IR Access (On/Off)
1.Control must be in Manual Mode. Refer to Entering the Manual Mode.
2.Press the #3 (>) or the #6 (<) keypad until
“Prog” appears in the display. Press the START (enter) keypad and “dCYC” will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “IrA” appears in the display.
4.When “IrA” appears in the display, press the START (enter) keypad. The current IR Access status will appear in the display.
“on” = Option Enabled “oFF” = Option Disabled
5.Press the #3 (>) or the #6 (<) keypad to change the current status.
6.Press the START (enter) keypad when the desired status appears in the display. The next option, “t FC” will appear in the display.
NOTE: To program “t FC” (Fahrenheit/Celsius), refer to option 7. To program other options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
Programming Control
7.Fahrenheit/Celsius “t FC”
This option allows the owner to set whether the display will be shown in Fahrenheit or Celsius.
How to Program Fahrenheit/Celsius
1.Control must be in Manual Mode. Refer to Entering the Manual Mode.
2.Press the #3 (>) or the #6 (<) keypad until
“Prog” appears in the display. Press the START (enter) keypad and “dCYC” will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “t FC” appears in the display.
4.When “t FC” appears in the display, press the START (enter) keypad. A number will appear in the display. This number (found below) corresponds to the current Fahrenheit/Celsius setting.
CEL = Celsius FAHr = Fahrenheit
5.Press the #3 (>) or the #6 (<) keypad to increase or decrease the current number to the desired number.
6.Press the START (enter) keypad when the correct number of degrees appears in the display. The new value is saved and the next option, “FH”, will appear in the display.
NOTE: To program “FH” (Hot Water Temperature), refer to option 8. To program other options, refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
F8208801 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 31 |