Alliance Laundry Systems PHM1263R manual Audio Signal AUd, How to Program the Audio Signal

Programming Control

2.Audio Signal “AUd”

This option allows the owner to program when the signal will sound.

There are two occasions when a signal may sound during operation. These two occasions are listed below:

1.End of Cycle Signal

By default, the signal is turned off. If turned on, the signal will sound for three seconds at the end of a cycle.

2.Keypad Depression Signal

By default, this signal is turned on and will sound for a quarter of a second. This signal will sound each time a keypad is pressed.

How to Program the Audio Signal

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the #3 (>) or the #6 (<) keypad until

“Prog” appears in the display. Press the START (enter) keypad and “dCYC” will appear in the display.

3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until “AUd” appears in the display.

4.When “AUd” appears in the display press the START (enter) keypad. A number will appear in the display. This number corresponds to the current Audio Signal Programming Value.

5.Locate the desired number in the first column of Table 2 on the following page.

6.Press the #3 (>) or the #6 (<) keypad to increase or decrease the current number until correct.

For Example: A user might wish to have the signal sound only when a keypad is pressed. Entering the number “1” in step 5 would turn off all the options except KEYPAD. In this instance, the signal would sound only when a keypad is pressed.

7.Press the START (enter) keypad when the correct number appears in the display. The next option, “Err-”, will appear in the display.

NOTE: To program “Err-”(Errors), refer to

.option 3 To program other options, refer to the appropriate section.

How to Exit Programming Feature

Press the #5 (<) keypad until the control returns to Start Mode.

20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F8208801