Alliance Laundry Systems PHM1263R manual Collecting Audit Information, How to Enter Audit Feature

Collecting Audit Information

This feature allows the owner to retrieve audit information stored in the washer-extractor by pressing a sequence of pads on the control.

How to Enter Audit Feature

1.Control must be in Manual Mode to start. Refer to Entering the Manual Mode.

2.Press the #3 (>) or the #6 (<) keypad until “AUdt” appears.

3.Press the START (enter) keypad. “CyC” will appear.

How to Read Audit Data

1.Use the #3 (>) or the #6 (<) keypad to scroll through various options until the desired option is shown in the display. Refer to the Audit Options List, Table 12, for an explaination of the audit options available.

Audit Options List

#Display Description

1“CyC” Total # of machine cycles

2“rCyC”* Total # of rapid advance cycles *This option is not available on Software Version 1.

Table 12

2.Press the START (enter) keypad once to start the audit count. At this point, the display will show the first four-digit segment of the audit value. If the audit count is 10,000 or higher, press the START (enter) keypad again to view the last four digits of the number.

NOTE: The display can show up to 4 digits at one time. Audit counts 10,000 or higher are separated into two 4-digit segments. Each time the START (enter) keypad is pressed in step 2, the display will show the next 4-digit segment in the audit value. If the value is 9,999 or less, only one 4-digit segment will be shown.

3.Press the START (enter) keypad again. The control will go to the next audit option in the Audit Options List.

4.To select other audit options, repeat steps 1-4.

How to Exit Audit Feature

Press the #5 (<) keypad.

42 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F8208801