Programming Control
4.Cycle Programming “Cy--”
This option allows the owner to program different aspects for various steps in each type of cycle. There are 30 cycles available for programming.
How to Enter Cycle Programming
1.Control must be in Manual Mode. Refer to Entering the Manual Mode.
2.Press the #3 (>) or the #6 (<) keypad until
“Prog” appears in the display. Press the START (enter) keypad and “dCYC” will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options until
4.Press the #3 (>) or the #6 (<) keypad to scroll through the 30 cycles to program. Press the START (enter) keypad when the desired cycle appears in the display.
5.The first Cycle Programming option, “Agit”, will appear in the display.
NOTE: To program “Agit” (Cycle Agitate), continue to next option. To program other options, press the #3 (>) or the #6 (<) keypad and refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
How to Program Cycle Agitate “AgIt”
This option allows the owner to program the cycle’s agitation action and speed. These options apply to the entire cycle.
1.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable Cycle Programming options until “Agit” appears in the display.
2.When “Agit” appears in the display, press the START (enter) keypad. The first Cycle Agitate option will appear in the display.
3.Press the #3 (>) or the #6 (<) keypad to scroll through the programmable options. Refer to Table 5.
4.Press the START (enter) keypad when the desired programmable option appears in the display. The current status will appear in the display. Refer to Table 5.
Final | Description |
| Status |
Spin Step |
| ||
|
|
|
|
“tyPE” | Agitate Type |
| |
|
| 1 | = 18/3/18 Agitation Action |
|
| 2 | = 10/20/10 Agitation Action |
|
| 3 | = 3/27/3 Agitation Action |
|
| 4 | = 4/56/4 Agitation Action |
|
|
|
|
“ASPd” | Agitate |
| “Lo” = Reduced Speed |
| Speed |
| “rEg” = Normal Speed |
| (VFD only) |
|
|
|
|
| |
| Table 5 | ||
5.Press the #3 (>) or the #6 (<) keypad to change the current status.
6.Press the START (enter) keypad when the desired status appears in the display. The next Cycle Agitate option will appear in the display.
NOTE: To program “SEg1” (Cycle Segment 1) press the #5 (<) keypad and continue to next Cycle Programming option. To program other options, press the #5 (<) keypad and refer to the appropriate section.
How to Exit Programming Feature
Press the #5 (<) keypad until the control returns to Start Mode.
26 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F8208801 |