Maytag W10239207B Reversing the Door Swing, Remove the Door Assembly, Reverse Hinge

REVERSING THE DOOR SWING

Door swing can be changed from a right-side opening to left-side opening, if desired.

Place a towel or soft cloth on top of the dryer or work space to avoid damaging the surface.

Remove the Door Assembly

1.Remove 3 of the 4 screws that hold the door hinge on the front panel of the dryer. Partially loosen the remaining screw with keyhole opening and lift the door off the screw.

A.

Loosen

screw with keyhole opening

B.

A.Dryer front panel

B.Door assembly

2.Lay the door assembly on a previously prepared flat surface with the inside (inner door assembly) facing up.

3.Remove the 6 Phillips head screws to release the outer door assembly from the inner door assembly, as indicated below. See illustration. It is important that you remove only the 6 indicated screws.

5.Rotate outer door 180°.

Reverse Hinge

1.Use a small flat-blade screwdriver to remove 2 plug strips from the inner door. Slide the head of the screwdriver under the plugs, being certain not to scratch the inner door surface. Lift up.

2.Remove the 4 screws that attach to the inner door hinge and move the hinge to the other side. Reinstall the 4 screws.

4.Lift the inner door assembly off the outer door assembly.

Door hinge

3.Reinstall plug strips on opposite side of the inner door.

4.Check for fingerprints on the glass. Clean glass if necessary.

11