MAIN BURNER IGNITION & USAGE
METHODS OF BURNER IGNITION
There are two ways to ignite burner 1. The first is by using the electronic Crossover® ignition system built into your grill. The second is with a match.
Next are the steps for igniting your grill using the electronic Crossover® ignition system.
On the following page are steps for igniting your grill with a match.
Summary lighting instructions are inside the cabinet door.
Some batteries have a plastic protective wrap around them. This plastic must be removed before you attempt to ignite your grill with the electronic Crossover® ignition system. Do not confuse this plastic with the battery label.
MAIN BURNER IGNITION
Electronic Crossover® Ignition System
The electronic Crossover® ignition system ignites burner 1 with a spark from the igniter electrode inside the Gas
Catcher™ ignition chamber. You generate the energy for1 the spark by pushing the igniter button. You will hear the
igniter clicking. Burner(s) 2 (and 3) can be lit after burner 1 is lit.
A) Open the grill lid (1).
m DANGER |
|
Failure to open the lid before igniting |
|
the grill’s burners, or not waiting five |
|
minutes to allow the gas to clear if the |
|
grill does not light, may result in an | 2 |
explosive | |
serious bodily injury or death. |
|
B) Make sure ALL burner control knobs are turned off
(2). Check by pushing control knobs in and turning them clockwise until they stop.
C) Turn the gas supply valve on (3).
D)Push burner 1 control knob in and turn it counterclockwise to start/high ( ) position (4).
| IMPORTANT: Always ignite burner 1 first. The other |
| ||
| burner(s) ignite from burner 1. |
| ||
E) | Push and hold in the igniter button (5). You will hear |
| ||
| the igniter clicking. |
| ||
F) | Check that burner 1 is lit by looking through the |
| ||
| cooking grates. You should see a flame. | 3 | ||
m WARNING: Do not lean over the open | ||||
| ||||
| grill. |
| ||
m WARNING: If burner 1 fails to ignite |
| |||
| within five seconds, stop, turn the |
| ||
| burner control knob to off and wait |
| ||
| five | minutes to allow the gas to clear |
| |
| before you try again or light with a |
| ||
| match. |
| ||
G) | After burner 1 is lit, you can turn on burner 2 (and |
| ||
| burner 3). | 4 | ||
TO EXTINGUISH BURNER | ||||
| ||||
Push each burner control knob in and turn it clockwise to |
| |||
the off ( | ) position. Turn gas supply off at the source. |
| ||
5
16WWW.WEBER.COM®