MAINTAINING THE ELECTRONIC CROSSOVER® IGNITION SYSTEM
The igniter module supplies power to the electronic Crossover® ignition system and the side burner with one igniter button. Whether you are performing routine maintenance or a troubleshooting check on the ignition system, read the following to keep your ignition system working properly.
If the electronic Crossover® ignition system fails to ignite, you'll need to pinpoint where the problem is occurring: with the gas flow or with the electronic ignition system. Begin by attempting to match light your burners. Refer to “MAIN BURNER IGNITION - Lighting with a Match.” If match lighting is successful, the problem lies in the ignition system.
•Verify that the AA battery (alkaline only) is in good condition and is installed correctly (1). Some batteries have a plastic protective wrap around them. This plastic must be removed before installing battery. Do not confuse this plastic with the battery label.
•Make sure the igniter wires are properly attached to the igniter module. Refer to the “IGNITER MODULE WIRE GUIDE” chart on this page.
•Make sure the ceramic igniter assembly is fully inserted into burner tube igniter channel (2). If properly positioned, you will hear a snap (3).
•Make sure the electronic igniter button is working by listening for clicking and looking for sparks at burner.
If the electronic Crossover® ignition system still fails to ignite, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
ROUTINE MAINTENANCE
1
2
3
IGNITER MODULE WIRE CHART (E210 / E310 / SP310) |
| |||
|
|
| 2 | 1 |
4 | 3 |
| 3 |
|
| 4 |
| ||
|
|
|
| |
| 2 | 1 |
|
|
BURNER 1 | IGNITER BUTTON |
| ||
Black Terminal (1) | Black Terminal (3) |
| ||
Yellow Terminal (2) | Black Terminal (4) |
| ||
26WWW.WEBER.COM®