A&D HC-30Ki, HC-15Ki, HC-3Ki, HC-6Ki manual Viewing the M+ Total, Clearing the M+ Total, M- Function

Automatic M+ Accumulation Mode

‰M+ Accumulation can also be done automatically each time you count a different batch, As soon as you have a stable count, it will be added to the M+ memory and the scale will beep . The weight display will have to return to near zero before another count can be added.

Automatic M+ accumulation is set by F-Function f-03-01 at “1”.

Only positive counts can be added. If F-Function f-03-02 is set at “1” (to accept negative count data), it will be ignored.

Once there is an automatic M+ accumulation, the display must return to less than +5d before another count can be accumulated.

6-2. Viewing the M+ TOTAL

1.Press the TOTAL key.

The count display will show the total count and the TOTAL annunciator will come ON.

The number of additions to the M+ memory is also shown.

2.Press the TOTAL key again. The display will return to normal.

6-3. Clearing the M+ TOTAL

		TOTAL			TOTAL Count
		annunciator
TOTAL		comes ON.		COUNT
TOTAL			88.81234
M+
			WEIGHT			UNIT WEIGHT
ENTERED	0000.8				88.88.8.8.7
STABLE
TARE
ZERO

Number of additions to M+ memory

1. Press and hold the C key, then press C

the TOTAL key – release both.

+

TOTAL

2.The scale will clear the M+ memory, and the TOTAL annunciator and the M+ annunciator will go OFF.

‰The RESET key does not clear the total data.

‰The total data is held in memory, even if AC/Battery power to scale is interrupted.

6-4. The M- Function

‰The scale can subtract count data from M+ memory by using the ½ key.

‰Set the F-Function f-09-01=‘1’ to use the ½ key as M- key.

This function is not to clear the last M+ addition, but to subtract count data instead of addition. The number of additions is increased.

There is no automatic M- function.

24