A&D HC-6Ki, HC-15Ki manual 88888100, 8f-00810 8f-05810, Comparator Function, To Set the Comparator

7.COMPARATOR FUNCTION

‰The scale contains a comparator function that checks the amount on the weighing pan against set acceptable count or weight levels. When the comparator function is

activated, “HI”, “OK” or “LO” indicator will be displayed.

‰Before the comparator will work, Upper and Lower Limits must be set (see below). The levels are set by count or weight. So, if you are using weight for your comparator levels, calculate the weight before starting the procedure below.

COUNT

88888100

beep, beep …

SAMPLE	HI	OK	LO
TOO LIGHT
Upper limit		102 pcs
Lower limit		98 pcs

The beeper is set ON at “OK”.

‰If the OP-04 is installed, comparator relay output is also available.

‰The comparator responds as follows,

“HI”	Upper Limits < Count / Weight Data
“OK”	Lower Limits ” Count / Weight Data ” Upper Limits
“LO”	Count / Weight Data < Lower Limits

To Set the Comparator

‰Start with the scale switched off.

1.Press and hold the ZERO key, then press the ON/OFF key – release both.

The count display will show “f-00” with “00” blinking.

2.Press the 5 key to enter into the

F-Function F-05-X Comparator section.

3.Press the ENTER key.

The count display will show the F-Function and its present setting will blink.

4. Use the 0 Æ 6 keys to display the number of the desired setting.

For example, let’s select “1” compare all data.

25

ZERO	+	ON
		OFF

8f-00810

58f-05810

ENTER 8f-05-01

0

8f-05-01

1