A&D EJ-4100, EJ-6100, EJ-440, EJ-3000, EJ-200, EJ-120 manual 060000, Calibration using a weight

Page 16

7. CALIBRATION

This function adjusts the balance for accurate weighing. Perform a calibration in the following cases.

When the balance is first used.

Calibration (CAL) switch

When the balance has been moved. For regular calibration.

Calibration (CAL) switch cover

7-1. Calibration using a weight

Prepare the calibration weight (sold separately) in advance.

	1. Warm up the balance for at least half an hour with				Press and hold
					the CAL switch.
	nothing on the pan.

	2. Press and hold the calibration (CAL) switch until				Cal
	Cal	appears, and release the switch.			Release the CAL switch.

	3. The balance displays			Cal 0 .
	To change the calibration weight value, proceed to				Cal 0
	step 4.
	To use the calibration weight value in the balance
	memory, proceed to step 5.
	4. Press the	SAMPLE		key. The display shows the	060000.
	calibration weight value in “gram” that is stored in the
	balance. Use the following keys to change the value.				Set the weight using

	SAMPLE	key	To	select the digit blinking to	the relevant keys.

change.

RE-ZERO		key	To set the value of the digit
			selected.
	key		To store the value and return to
PRINT	key		To store the value and return to
			step 3.

Cal 0

UNITS

key	To cancel the value and return to
	step 3.

14

Image 16

Contents 1WMPD4001917 This manual and Marks Compliance with FCC rulesContents Maintenance Introduction UnpackingNET indicator Part Names and FunctionsSetting up your balance Setting UPPower source Breeze break Installing batteriesStorage Operation Turn the power on and OFFLCD backlight Units Conversion tableSelecting a weighing unit NETBasic operation Counting mode pcs Selecting the counting modeCounting mode using the Acai function Storing the sample unitPercent mode % 100100 0 % 1000. %Setting example Selecting a comparison modeComparator FuncCp Hi 000000 001234Cp lo 000000 001230Calibration using a weight CalibrationCal 060000Cal 50000 GlpCal 97985 Gravity acceleration correctionEntering the function setting mode FunctionsCp Hi Key operationACai Func PoffEnd Cp Hi End id UnitStoring weighing units Function list Func ACai UminSmpl LdinEJ-03 Installation OptionsEJ-02 USB Interface EJ-03 RS-232C serial interfaceInterface specifications EIA RS-232CData output mode Data formatCommand mode Command listEJ-07 / EJ-08 Installation EJ-07 / EJ-08 UnderhookEJ-11 Breeze break EJ-12 Carrying caseEJ-13 Density Determination Kit EJ-13 InstallationDensity specific gravity measurement Change the function table 000Example of density measurement 2000 1751 8801Setting the ID number ID Number and GLPEnd id func Display character setData format for calibration report Output exampleData format for calibration test report Calibration test using a weight TitleEnd Block Title block and End block20000 20000 EndMaintenance Error codesOverload error Range over notice Unit weight error Sample quantity noticeError1 Cal e -Cal eLb0 Hb0 Hb1 Lb1Specifications EJ seriesOther weighing units Dimensions OptionsGravity Acceleration MAP Values of gravity at various locationsWorld map