A&D EJ-120, EJ-6100, EJ-440, EJ-3000, EJ-4100, EJ-2000, EJ-1500 manual Command mode, Command list

Page 27

Key mode

Set the function “prt 1, 2 or 3”.

When the PRINT key is pressed while the weighing data is stable (the STABLE indicator is on), the balance transmits the data. When the data is transmitted, the display will blink one time.

Auto-print mode A

Set the function “prt 2”.

The balance transmits the weighing data when the display is stable (the STABLE indicator is on) and the data is greater than +4d.

The next output can be obtained after the display returns below +4d.

Auto-print mode B

Set the function “prt 3”.

The balance transmits the weighing data when the display is stable (the STABLE indicator is on) and the data is greater than +4d or less than -4d.

The next output can be obtained after the display returns between -4d and +4d.

Command mode

In the command mode, the balance is controlled by commands that come from the personal computer and so on.

Command list

Command to request the current weighing data.

Command

Reply

Q CR LF

S	T	,	+	0	0	1	2	3	4	.	5							g	CR	LF

Command to zero or tare the balance (same as the

Command Z CR LF

RE-ZERO

key).

Reply

Z CR LF

Command to change the weighing units (same as the

Command	U	CR	LF

Reply	U	CR	LF

MODE

key).

25

Image 27

Contents 1WMPD4001917 Compliance with FCC rules This manual and MarksContents Maintenance Unpacking IntroductionPart Names and Functions NET indicatorSetting UP Setting up your balancePower source Installing batteries Breeze breakStorage Turn the power on and OFF OperationLCD backlight Conversion table UnitsNET Selecting a weighing unitBasic operation Storing the sample unit Counting mode pcsSelecting the counting mode Counting mode using the Acai function1000. % Percent mode %100 100 0 %Func Setting exampleSelecting a comparison mode Comparator001230 Cp Hi 000000001234 Cp lo 000000060000 Calibration using a weightCalibration CalGlp Cal 50000Gravity acceleration correction Cal 97985Key operation Entering the function setting modeFunctions Cp HiFunc Poff ACaiEnd Cp Hi Unit End idStoring weighing units Function list Ldin Func ACaiUmin SmplEJ-03 RS-232C serial interface EJ-03 InstallationOptions EJ-02 USB InterfaceEIA RS-232C Interface specificationsData format Data output modeCommand list Command modeEJ-12 Carrying case EJ-07 / EJ-08 InstallationEJ-07 / EJ-08 Underhook EJ-11 Breeze breakEJ-13 Installation EJ-13 Density Determination KitDensity specific gravity measurement 000 Change the function tableExample of density measurement 1751 8801 2000Display character set Setting the ID numberID Number and GLP End id funcOutput example Data format for calibration reportData format for calibration test report Title block and End block Calibration test using a weightTitle End Block20000 End 20000Range over notice Unit weight error Sample quantity notice MaintenanceError codes Overload errorHb1 Lb1 Error1Cal e -Cal e Lb0 Hb0EJ series SpecificationsOther weighing units Options DimensionsValues of gravity at various locations Gravity Acceleration MAPWorld map