A&D EJ-2000, EJ-6100, EJ-440, EJ-3000, EJ-4100, EJ-120 Breeze break, Storage, Installing batteries

Page 8

Remove batteries when the balance is not to be used for a long time. They may leak and cause damage to the balance.

Damage due to battery leakage is not covered by the warranty.

Installing batteries

1.Turn off the balance and disconnect the AC adapter if used.

2.Slide the battery cover off.

3.Push the battery box up to unhook and pull it out.

4. Insert new four batteries (LR6 / R6P / AA size) into the battery box, taking extreme care of the polarities.

5.Push the battery box into the balance as before.

6.Attach the battery cover.

Battery cover

Hook

Battery box

Hook

Battery indicator turns on when the balance is operated by the batteries. It will change as the battery voltage decreases.

New Æ Æ Æ Coming close to “lb0”.

4-3. Breeze break

The optional breeze break is available. See “9-4. EJ-11 Breeze break”.

4-4. Storage

The EJ series balance can stack on top of another when not in use.

Do not stack more than 3 units.

Image 8

Contents 1WMPD4001917 This manual and Marks Compliance with FCC rulesContents Maintenance Introduction UnpackingNET indicator Part Names and FunctionsPower source Setting UPSetting up your balance Storage Installing batteriesBreeze break LCD backlight Turn the power on and OFFOperation Units Conversion tableBasic operation NETSelecting a weighing unit Counting mode pcs Selecting the counting modeCounting mode using the Acai function Storing the sample unitPercent mode % 100100 0 % 1000. %Setting example Selecting a comparison modeComparator FuncCp Hi 000000 001234Cp lo 000000 001230Calibration using a weight CalibrationCal 060000Cal 50000 GlpCal 97985 Gravity acceleration correctionEntering the function setting mode FunctionsCp Hi Key operationEnd Cp Hi Func PoffACai Storing weighing units UnitEnd id Function list Func ACai UminSmpl LdinEJ-03 Installation OptionsEJ-02 USB Interface EJ-03 RS-232C serial interfaceInterface specifications EIA RS-232CData output mode Data formatCommand mode Command listEJ-07 / EJ-08 Installation EJ-07 / EJ-08 UnderhookEJ-11 Breeze break EJ-12 Carrying caseDensity specific gravity measurement EJ-13 InstallationEJ-13 Density Determination Kit Example of density measurement 000Change the function table 2000 1751 8801Setting the ID number ID Number and GLPEnd id func Display character setData format for calibration test report Output exampleData format for calibration report Calibration test using a weight TitleEnd Block Title block and End block20000 20000 EndMaintenance Error codesOverload error Range over notice Unit weight error Sample quantity noticeError1 Cal e -Cal eLb0 Hb0 Hb1 Lb1Specifications EJ seriesOther weighing units Dimensions OptionsGravity Acceleration MAP Values of gravity at various locationsWorld map