A&D EJ-1500, EJ-6100, EJ-440, EJ-3000, EJ-200 EJ-13 Density Determination Kit, EJ-13 Installation

Page 29

9-6. EJ-13 Density Determination Kit

Using this

option and calculation

Fixing frame

Weighing pan

program, the balance can determine

 

 

the density

(specific gravity) of a

 

 

sample.

 

 

 

EJ-13 Installation

‰Push the fixing frame out, and

remove the weighing pan.

‰Attach the beaker stand to the balance and fit the pan stand to the pan support of the balance.

Sample weighing pan

Upper pan to weigh in air

Pan stand

Lower pan to weigh in water

Pan support

Beaker

‰Place a beaker filled with water on the beaker stand and place the sample weighing pan on top of the pan stand.

Density (specific gravity) measurement

‰The density of a liquid can be changed and there are two ways of setting. One is to set the water temperature and the other is to set density value directly.

‰The factory setting for density of a liquid is 25 °C as water temperature (the density value ρ = 0.99704 (g/cm3) is used to calculate).

‰The density (specific gravity) is calculated by the following formula.

S = A X ρ

A-B

S:Density (specific gravity) of a sample

A:Weight in air

B:Weight in liquid

ρ: Density of liquid (water)

‰The result is shown with two decimal places.

27

Image 29
Contents 1WMPD4001917 Compliance with FCC rules This manual and MarksContents Maintenance Unpacking IntroductionPart Names and Functions NET indicatorPower source Setting UPSetting up your balance Storage Installing batteriesBreeze break LCD backlight Turn the power on and OFFOperation Conversion table UnitsBasic operation NETSelecting a weighing unit Selecting the counting mode Counting mode pcsCounting mode using the Acai function Storing the sample unit100 Percent mode %100 0 % 1000. %Selecting a comparison mode Setting exampleComparator Func001234 Cp Hi 000000Cp lo 000000 001230Calibration Calibration using a weightCal 060000Glp Cal 50000Gravity acceleration correction Cal 97985Functions Entering the function setting modeCp Hi Key operationEnd Cp Hi Func PoffACai Storing weighing units UnitEnd id Function list Umin Func ACaiSmpl LdinOptions EJ-03 InstallationEJ-02 USB Interface EJ-03 RS-232C serial interfaceEIA RS-232C Interface specificationsData format Data output modeCommand list Command modeEJ-07 / EJ-08 Underhook EJ-07 / EJ-08 InstallationEJ-11 Breeze break EJ-12 Carrying caseDensity specific gravity measurement EJ-13 InstallationEJ-13 Density Determination Kit Example of density measurement 000Change the function table 1751 8801 2000ID Number and GLP Setting the ID numberEnd id func Display character setData format for calibration test report Output exampleData format for calibration report Title Calibration test using a weightEnd Block Title block and End block20000 End 20000Error codes MaintenanceOverload error Range over notice Unit weight error Sample quantity noticeCal e -Cal e Error1Lb0 Hb0 Hb1 Lb1EJ series SpecificationsOther weighing units Options DimensionsValues of gravity at various locations Gravity Acceleration MAPWorld map