A&D EJ-1500, EJ-6100, EJ-440, EJ-3000, EJ-200 Operation, Turn the power on and OFF, LCD backlight

Page 9

5. OPERATION

5-1. Turn the power ON and OFF

1. Press the

ON:OFF

key to turn the power ON.

STABLE

 

Weighing

NET

 

 

units

ZERO

 

 

 

 

 

All of the symbols are displayed as shown above. (About units: Only the units available will be displayed.)

The display turns off except for a weighing unit and the decimal point.

The balance waits for the weighing data to become stable, and zero will be displayed with the ZERO indicator (power-on zero).

The range for power-on zero is within ±10% of the weighing capacity around the calibrated zero point.

If the power is switched ON while there is a load beyond this range, the balance will be tared to zero and the NET indicator and the ZERO indicator turn on.

2. Press the

ON:OFF

key again, and the power will be switched OFF.

‰Auto-power off function

It is possible to have the power automatically switched OFF, if zero is displayed for approximately 5 minutes. See “8-5. Function list” and set the function “poff”.

5-2. LCD backlight

The LCD backlight will turn on when the weight value changes more than 4d (4 x min. display division) or any key operation is done. When the weight data becomes and stays stable for some moment, the backlight will automatically turn off. There is also a setting that the backlight is always on or off. For details, see the function setting “ltUp” of “Function list”.

7

Image 9
Contents 1WMPD4001917 Compliance with FCC rules This manual and MarksContents Maintenance Unpacking IntroductionPart Names and Functions NET indicatorSetting UP Setting up your balancePower source Installing batteries Breeze breakStorage Turn the power on and OFF OperationLCD backlight Conversion table UnitsNET Selecting a weighing unitBasic operation Selecting the counting mode Counting mode pcsCounting mode using the Acai function Storing the sample unit100 Percent mode %100 0 % 1000. %Selecting a comparison mode Setting exampleComparator Func001234 Cp Hi 000000Cp lo 000000 001230Calibration Calibration using a weightCal 060000Glp Cal 50000Gravity acceleration correction Cal 97985Functions Entering the function setting modeCp Hi Key operationFunc Poff ACaiEnd Cp Hi Unit End idStoring weighing units Function list Umin Func ACaiSmpl LdinOptions EJ-03 InstallationEJ-02 USB Interface EJ-03 RS-232C serial interfaceEIA RS-232C Interface specificationsData format Data output modeCommand list Command modeEJ-07 / EJ-08 Underhook EJ-07 / EJ-08 InstallationEJ-11 Breeze break EJ-12 Carrying caseEJ-13 Installation EJ-13 Density Determination KitDensity specific gravity measurement 000 Change the function tableExample of density measurement 1751 8801 2000ID Number and GLP Setting the ID numberEnd id func Display character setOutput example Data format for calibration reportData format for calibration test report Title Calibration test using a weightEnd Block Title block and End block20000 End 20000Error codes MaintenanceOverload error Range over notice Unit weight error Sample quantity noticeCal e -Cal e Error1Lb0 Hb0 Hb1 Lb1EJ series SpecificationsOther weighing units Options DimensionsValues of gravity at various locations Gravity Acceleration MAPWorld map