A&D EJ-6100, EJ-440, EJ-3000, EJ-4100, EJ-120, EJ-2000, EJ-1500 manual 1751 8801

Page 31

2.Place a sample on the upper pan.

3.Wait for the STABLE indicator to be displayed and press the SAMPLE key to store the weight in air.

4.The display shows that LO blinks and the balance starts to measure weight in water.

5.Place the sample on the lower pan in water.

Adjust the amount of water so that the sample is about 10 mm below water surface.

6.Wait for the STABLE indicator to be displayed and press the SAMPLE key. Then the balance reads the weight in water and shows the density (specific gravity) of the sample.

7.To continue the specific gravity measurement, press the SAMPLE key again. To exit this measurement, press the UNITS key.

HI SG

2000.

Measuring weight in water.

LO SG

2000.

LO SG

1751.

8801.

The display shows the density.

To weigh in air.

To weigh in water.

Image 31

Contents 1WMPD4001917 Compliance with FCC rules This manual and MarksContents Maintenance Unpacking IntroductionPart Names and Functions NET indicatorSetting up your balance Setting UPPower source Breeze break Installing batteriesStorage Operation Turn the power on and OFFLCD backlight Conversion table UnitsSelecting a weighing unit NETBasic operation Storing the sample unit Counting mode pcsSelecting the counting mode Counting mode using the Acai function1000. % Percent mode %100 100 0 %Func Setting exampleSelecting a comparison mode Comparator001230 Cp Hi 000000001234 Cp lo 000000060000 Calibration using a weightCalibration CalGlp Cal 50000Gravity acceleration correction Cal 97985Key operation Entering the function setting modeFunctions Cp HiACai Func PoffEnd Cp Hi End id UnitStoring weighing units Function list Ldin Func ACaiUmin SmplEJ-03 RS-232C serial interface EJ-03 InstallationOptions EJ-02 USB InterfaceEIA RS-232C Interface specificationsData format Data output modeCommand list Command modeEJ-12 Carrying case EJ-07 / EJ-08 InstallationEJ-07 / EJ-08 Underhook EJ-11 Breeze breakEJ-13 Density Determination Kit EJ-13 InstallationDensity specific gravity measurement Change the function table 000Example of density measurement 1751 8801 2000Display character set Setting the ID numberID Number and GLP End id funcData format for calibration report Output exampleData format for calibration test report Title block and End block Calibration test using a weightTitle End Block20000 End 20000Range over notice Unit weight error Sample quantity notice MaintenanceError codes Overload errorHb1 Lb1 Error1Cal e -Cal e Lb0 Hb0EJ series SpecificationsOther weighing units Options DimensionsValues of gravity at various locations Gravity Acceleration MAPWorld map