A&D EJ-2000, EJ-6100, EJ-440 manual EJ-07 / EJ-08 Underhook, EJ-11 Breeze break, EJ-12 Carrying case

Page 28

9-3. EJ-07 / EJ-08 Underhook

By attaching the underhook to the bottom of the balance, large objects that are difficult to load on the weighing pan can be weighed, and the density (specific gravity) of objects may be measured. Refer to the “9-6. EJ-13 Density Determination Kit” for the information about the density measurement.

EJ-07 is for use with the EJ-3000 / EJ-4100 / EJ-6100.

EJ-08 is for use with the EJ-1500 / EJ-2000.

The calibration with a weight being hung on the hook is required for an accurate weighing.

EJ-07 / EJ-08 Installation

Open the cap on the bottom of the balance, and screw the underhook into the mounting hole.

Remove the cap.

Caution	EJ-07	EJ-08
Caution

Do not apply excessive force to the underhook.

When not in use, remove the underhook and attach the cap to prevent dust from getting into the balance.

9-4. EJ-11 Breeze break

EJ-11 will be used mainly for min. display 0.01 g models. But all of EJ series can use this option unit.

Remove the fixing frame out.

Attach the breeze break frame instead of the fixing frame.

	Attach the breeze break to the balance.	Breeze break
	Fixing frame	Breeze break
	Fixing frame

Breeze break frame

9-5. EJ-12 Carrying case

EJ-12 is available for the convenience of carrying the balance by hand. However, note that because these balances are precision equipment, they will not be able to withstand excessive shock, such as being dropped.

26

Image 28

Contents 1WMPD4001917 This manual and Marks Compliance with FCC rulesContents Maintenance Introduction UnpackingNET indicator Part Names and FunctionsSetting up your balance Setting UPPower source Breeze break Installing batteriesStorage Operation Turn the power on and OFFLCD backlight Units Conversion tableSelecting a weighing unit NETBasic operation Counting mode pcs Selecting the counting modeCounting mode using the Acai function Storing the sample unitPercent mode % 100100 0 % 1000. %Setting example Selecting a comparison modeComparator FuncCp Hi 000000 001234Cp lo 000000 001230Calibration using a weight CalibrationCal 060000Cal 50000 GlpCal 97985 Gravity acceleration correctionEntering the function setting mode FunctionsCp Hi Key operationACai Func PoffEnd Cp Hi End id UnitStoring weighing units Function list Func ACai UminSmpl LdinEJ-03 Installation OptionsEJ-02 USB Interface EJ-03 RS-232C serial interfaceInterface specifications EIA RS-232CData output mode Data formatCommand mode Command listEJ-07 / EJ-08 Installation EJ-07 / EJ-08 UnderhookEJ-11 Breeze break EJ-12 Carrying caseEJ-13 Density Determination Kit EJ-13 InstallationDensity specific gravity measurement Change the function table 000Example of density measurement 2000 1751 8801Setting the ID number ID Number and GLPEnd id func Display character setData format for calibration report Output exampleData format for calibration test report Calibration test using a weight TitleEnd Block Title block and End block20000 20000 EndMaintenance Error codesOverload error Range over notice Unit weight error Sample quantity noticeError1 Cal e -Cal eLb0 Hb0 Hb1 Lb1Specifications EJ seriesOther weighing units Dimensions OptionsGravity Acceleration MAP Values of gravity at various locationsWorld map