A&D EJ-6100, EJ-440, EJ-3000, EJ-200, EJ-4100, EJ-120 manual Unit, End id, Storing weighing units

Page 21

8-4. Storing weighing units

It is possible to store the weighing units that will be actually used from the units available. For the units available, see “5-3. Units”.

Select and store the weighing units as described below:

1.Press and hold the func .

SAMPLE

key to display

Press and hold

2.Press the Unit

.

SAMPLE

func

key several times to display	Press
	several times

3. Press the

PRINT

Unit

key.

4.Press the SAMPLE key to display a weighing unit to be stored.

5. Press the RE-ZERO key to select the weighing unit. The selected weighing unit is shown with the STABLE indicator.

At this stage, the weighing unit is not stored in memory.

6.Repeat steps 4. and 5. to store all weighing units to be used.


7. Press the			PRINT	key to store the selected weighing
	units in memory.
	id		appears after		end	.

8.Press the UNITS key to return to the weighing mode.

Note

When the balance is switched on, it starts with the unit that was stored first at step 5.

Unit

Each pressing switches the units available in the order described on 5-3.

Unit

To select

To store

end id

Returns to

the weighing mode

19

Image 21

Contents 1WMPD4001917 Compliance with FCC rules This manual and MarksContents Maintenance Unpacking IntroductionPart Names and Functions NET indicatorSetting UP Setting up your balancePower source Installing batteries Breeze breakStorage Turn the power on and OFF OperationLCD backlight Conversion table UnitsNET Selecting a weighing unitBasic operation Selecting the counting mode Counting mode pcsCounting mode using the Acai function Storing the sample unit100 Percent mode %100 0 % 1000. %Selecting a comparison mode Setting exampleComparator Func001234 Cp Hi 000000Cp lo 000000 001230Calibration Calibration using a weightCal 060000Glp Cal 50000Gravity acceleration correction Cal 97985Functions Entering the function setting modeCp Hi Key operationFunc Poff ACaiEnd Cp Hi Unit End idStoring weighing units Function list Umin Func ACaiSmpl LdinOptions EJ-03 InstallationEJ-02 USB Interface EJ-03 RS-232C serial interfaceEIA RS-232C Interface specificationsData format Data output modeCommand list Command modeEJ-07 / EJ-08 Underhook EJ-07 / EJ-08 InstallationEJ-11 Breeze break EJ-12 Carrying caseEJ-13 Installation EJ-13 Density Determination KitDensity specific gravity measurement 000 Change the function tableExample of density measurement 1751 8801 2000ID Number and GLP Setting the ID numberEnd id func Display character setOutput example Data format for calibration reportData format for calibration test report Title Calibration test using a weightEnd Block Title block and End block20000 End 20000Error codes MaintenanceOverload error Range over notice Unit weight error Sample quantity noticeCal e -Cal e Error1Lb0 Hb0 Hb1 Lb1EJ series SpecificationsOther weighing units Options DimensionsValues of gravity at various locations Gravity Acceleration MAPWorld map