RCA 25425RE1A manual Interference Information

Page 3

Important Information

you the opportunity to correct the situation; and (3) inform you of your right to bring a complaint to the Commission pursuant to procedures set forth in Subpart E of Part 68, FCC Rules and Regulations.

The telephone company may make changes in its communications facilities, equipment, operations or procedures where such action is required in the operation of its business and not inconsistent with FCC Rules and Regulations. If these changes are expected to affect the use or performance of your telephone equipment, the telephone company must give you adequate notice, in writing, to allow you to maintain uninterrupted service.

Interference Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna (that is, the antenna for radio or television that is “receiving” the interference).

•Reorient or relocate and increase the separation between the telecommunications equipment and receiving antenna.

•Connect the telecommunications equipment into an outlet on a circuit different from that to which the receiving antenna is connected.

If these measures do not eliminate the interference, please consult your dealer or an expe- rienced radio/television technician for additional suggestions. Also, the Federal Communi- cations Commission has prepared a helpful booklet, “How To Identify and Resolve Radio/TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402. Please specify stock number 004-000-00345-4 when ordering copies.

Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.



Page 2 Page 4
Image 3
Page 2 Page 4
Contents Quick Guide on Pgs ModelRights of the Telephone Company Important InformationEquipment Approval Information Notification to the Local Telephone CompanyInterference Information FCC RF Radiation Exposure Statement LicensingHearing Aid Compatibility Table of Contents Storing the Last Number Dialed Introduction Connections & SetupParts Checklist Important Installation InformationTelephone Jack Requirements Attendant Base LayoutInstalling the Phone Important Installation GuidelinesConnections & Setup Connect the handset cord Data PortTo set the Mailbox System VerificationOther System Phones Answering systemAuto Attendant VolumeProgramming the Telephone Programming the TelephonePriority Line Ringer ToneDelay Ring Phone IDPhone Name Flash Time Intercom Auto AnswerCall Alert Tone No Unknown/BlockedDisplay Contrast Regional Area Codes Local Area CodeHour Format Manually Setting the Time and DateProgramming the Answering System Restoring the Default SettingsPickup Delay Programming the Answering SystemMessage Length Call ScreeningMessage Interrupt Mailbox Remote PasswordSet Day Time for Auto Attendant Auto Attendant Pickup DelayProgramming the Auto Attendant Programming the Auto AttendantSet Night Time on / OFF Set Night Time for Auto AttendantSet Valid ID Basic OperationBasic Operation Set Weekend GreetingMaking Calls with the Handset Making Calls with the SpeakerphoneMaking Calls with the Optional Headset Mute Switching Between the Speakerphone, Handset, and HeadsetPre-dialing Answering Calls If you receive a call on the priority lineRedial Do Not DisturbHold FlashReviewing the Redial Numbers Transferring a Call to Another StationReceiving a Transferred Call from Another Station To disconnect one party PrivacyConference Calls To connect and conferenceAnswering an Intercom Call Intercom CallsIntercom Calls One-Touch IntercomPaging All Stations Intercom Conference CallsReceiving and Storing CID Records Caller IDCaller ID Summary ScreenDeleting All Call Records If You Programmed Your Local Area CodeIf You Did Not Program Your Local Area Code Deleting a CID RecordStoring a Number and Name in Memory MemoryCall Waiting Caller ID Memory Log and Phone Book Directory MemoryReviewing Phone Book Directory Memory Reviewing the Intercom/Memory Log memory locationStoring the Last Number Dialed Storing a Pause in Memory Dialing a Stored NumberMemory Delete/Clear For example Clear All MemoriesChain Dialing Recording a Greeting Answering System OperationAnswering System Turning the Answering System On/OffTwo-Way Recording Recording Incoming MessagesMonitoring Incoming Calls Memo RecordingDeleting Messages To delete messages Accessing the Answering System from Another LocationConnecting with the Answering System Message PlaybackToll Saver Operation Auto Attendant Sequence for Callers Auto Attendant OperationAuto Attendant Turn Auto Attendant On/OffPlayback and Erasing Auto Attendant Greetings Display Messages Using Multiple Auto AttendantsTroubleshooting Guide Troubleshooting GuideOperation By Battery Operation without PowerGeneral Product Care Warranty Information Warranty AssistanceAccessory Information Thomson, Inc Alameda Ave Socorro, Texas Limited WarrantyWarranty Information Index Index Thomson Inc
Top Page Image Contents