ClearSounds CSC40 Volume Reset Override, Outgoing Speech Volume, Dialing Stored Numbers

Volume Reset Override

In standard mode, the phone will reset to normal sound levels when you hang up. This allows people who do not require the level of amplification offered on the phone to use it. If you would like to override the reset, simply turn the AUTO AMPLIFY switch on the back of the phone to “ON” (See diagram #13).

IMPORTANT: When the AUTO AMPLIFY switch is in the “ON” position, you do not need to press the AMPLIFY button. Your amplification setting will remain as set.

DIAGRAM #13 - Volume override switch

Using Your CSC40 Phone with Hearing Aids

Your CSC40 Phone can be used with hearing aids equipped with a telecoil (T-coil). Adjust your hearing aid “T-switch” to the “T” position. Make sure to hold the handset close to your hearing aid.

Outgoing Speech Volume

You can adjust the sending volume (outgoing volume up to 12 dB) by using the Speech Volume Control located on the back of the CSC40 phone. If your voice is faint or weak, adjust the volume to “HI”. You can also decrease the volume as well. There are three levels available “LO, NORMAL & HI” (See diagram #14).

DIAGRAM #14 – Outgoing speech volume switch

Dialing Stored Numbers

1.Lift the handset and listen for the dial tone.

2.Press the appropriate location button M1 – M12 and the number stored in this location will be dialed automatically (See diagram #15).

DIAGRAM #15 – Memory Dial button

12