Multi-Tech Systems MVP103, 410 manual Communication Manager MultiVOIP FXS Channels

Page 11

Chapter 2 - Configuration

handset (and without dialing the number) immediately call the far-end party. To prevent toll fraud on FXO trunk ports, set the “autocall enable” feature and enter the phone number for a receptionist or auto-attendent.

3c. The MultiVOIP supports off-hook alerting on FXS ports. To enable the feature, set the “auto call/off-hook alert” feature to “off-hook alert” and enter the destination number in the “phone number” field. If the user lifts the handset, but does not dial a number, dial tone will be heard for 10 seconds, followed by intercept tone for the number of seconds configured in the “off-hook alert timer” field. If this timer expires, a call will automatically be placed to the destination number in the “phone number” field.

4.Configure the station (FXS) channels in the Communication Manager Parameters screen.

Communication Manager MultiVOIP: FXS Channels

4a. Make sure the “Register with Communication Manager Gatekeeper” option is checked.

4b. Configure Call Signaling Port. This needs to be unique on each registered FXS channel and must fall within the range of port values supported by Communication Manager. Typically, it is OK to use the default values 1721-1728 on channels 1-8 respectively.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

11

Image 11

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Mode Fax FRF 11 T.38 Fax EnableFax Volume Jitter Value Default =Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options Policy GK General SettingsGK General Settings Definitions Activity ConfigurationRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons ID alias of the endpoint originating the call Gatekeeper CallsCurrent Calls Field Definitions Number. a sequential number for identification in the listID identifies the call with which the message is associated Call Details Field DefinitionsConference ID number CID is a unique non-zero value created Conference will have the same CIDReason associated with the last state of the call Total amount of bandwidth used by the callType of conference request create, invite or join Last reported state of the callAddress and port number H.323 alias name used to make the callE164 alias phone number used to make the call An e-mail address used to make the callOptions Gatekeeper Network ParametersNetwork Parameter Definitions Field Name Values Description Status InformationLine Hunting Information ARQCall Mode GK-ID Public Gatekeeper ServicesServices Screen Definitions Field Name Values Description GK Defined ServicesDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP210-AV Rev a MVP130-AV RevMVP130-AV Rev a MVP130-AV-FXS Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones