Multi-Tech Systems MVP103, 410 manual = Isdn

Page 19

Chapter 2 - Configuration

6f. To accommodate the MultiVOIP unit, the following fields in the Communication Manager “Trunk Group – Page 1” form must be set as shown:

Dial Access?	= n

Service Type	= tie

Group Type	= ISDN

Carrier Medium	= IP/H.323

6g. To accommodate the MultiVOIP unit, all of the MultiVOIP’s DID channels must be listed as trunk- group members in the Communication Manager Trunk Group form (“Change Trunk-Group” dialog box).

For example, if four channels of an MVP810-AV are configured as DID, four trunk group numbers must be listed, as above.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

19

Image 19

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Mode Fax FRF 11 T.38 Fax EnableFax Volume Jitter Value Default =Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options Policy GK General SettingsGK General Settings Definitions Activity ConfigurationRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons ID alias of the endpoint originating the call Gatekeeper CallsCurrent Calls Field Definitions Number. a sequential number for identification in the listID identifies the call with which the message is associated Call Details Field DefinitionsConference ID number CID is a unique non-zero value created Conference will have the same CIDReason associated with the last state of the call Total amount of bandwidth used by the callType of conference request create, invite or join Last reported state of the callAddress and port number H.323 alias name used to make the callE164 alias phone number used to make the call An e-mail address used to make the callOptions Gatekeeper Network ParametersNetwork Parameter Definitions Field Name Values Description Status InformationLine Hunting Information ARQCall Mode GK-ID Public Gatekeeper ServicesServices Screen Definitions Field Name Values Description GK Defined ServicesDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP210-AV Rev a MVP130-AV RevMVP130-AV Rev a MVP130-AV-FXS Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones