Multi-Tech Systems MVP103, 410 manual Configuration

Page 23

Chapter 2 - Configuration

7f. Configure the “Survivable GK Node Name” field with the node name previously given to the MultiVOIP in the “Node-Names IP” form.

Avaya IP phones running firmware version 2.0 or higher require CM 2.0.1 or higher to work in survivable mode with the MultiVOIP. When these phones register with the CM, they replace the list of gatekeepers acquired from the DHCP server (including the MultiVOIP) with a new list of gatekeepers acquired from CM. This differs from 1.x IP phone firmware where the gatekeeper list sent to the IP phone from CM was appended to the list of gatekeepers acquired from the DHCP server. When using CM 2.0.1 or higher, configure the “Survivable GK Node Name” field in the station form for the IP phone. By doing this, the MultiVOIP will be included in the list of gatekeepers sent to the IP phone by CM.

Note: IP phone models 4610SW and 4620SW only support 2.0 or higher firmware, therefore these phones cannot be used with the MultiVOIP unless you are using CM 2.0.1 or higher.

7g. The completed Endpoints screen is shown below:

7h. Click on Save SetupSave GK Parameters to save the gatekeeper settings.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

23

Image 23

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Mode Fax FRF 11 T.38 Fax EnableFax Volume Jitter Value Default =Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options Policy GK General SettingsGK General Settings Definitions Activity ConfigurationRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons ID alias of the endpoint originating the call Gatekeeper CallsCurrent Calls Field Definitions Number. a sequential number for identification in the listID identifies the call with which the message is associated Call Details Field DefinitionsConference ID number CID is a unique non-zero value created Conference will have the same CIDReason associated with the last state of the call Total amount of bandwidth used by the callType of conference request create, invite or join Last reported state of the callAddress and port number H.323 alias name used to make the callE164 alias phone number used to make the call An e-mail address used to make the callOptions Gatekeeper Network ParametersNetwork Parameter Definitions Field Name Values Description Status InformationLine Hunting Information ARQCall Mode GK-ID Public Gatekeeper ServicesServices Screen Definitions Field Name Values Description GK Defined ServicesDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP210-AV Rev a MVP130-AV RevMVP130-AV Rev a MVP130-AV-FXS Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones