Multi-Tech Systems 410, MVP103 manual Configuration

Page 8

Chapter 2 – Configuration

2.Configure Interface Parameters.

2a. Determine which voice channels will be stations (FXS), trunks (FXO/DID), or disabled. Configure them as such in the Configuration Interface screen of the MultiVOIP GUI.

2b. If you are configuring a DID-DPO (Direct Inward Dial – dial-pulse originating) interface for DID incoming calls, you need to chose DID-DPO from the pull down menu for Interface Type. You also have to set the DID Options Start Modes; Immediate Start, Wink Start, or Delay Dial.

Immediate Start allows the MultiVOIP to detect the off-hook condition at the originating end of the call and becomes ready to receive the digits immediately.

Wink Start allows the MultiVOIP to detect the off-hook condition at the originating end of the call. The MultiVOIP then reverses the battery polarity for a specified time (140-290 ms; a “wink”) and then becomes ready to receive the dialed digits. You can select the Wink Timer duration (140 to 290 ms).

Delay Dial allows the MultiVOIP to detect the off-hook condition at the originating end of the call. Then the MultVOIP reverses battery polarity for a specified time (reverse polarity duration has a wider acceptable range than Wink Start) and then becomes ready to receive dialed digits.

2c. Enable the “Message Waiting Light” feature if you have FXS Interface selected and are using an Avaya analog telephone with Message Waiting indicator or enable “Stutter Dial Tone” if you are

8	Multi-Tech Systems, Inc. Avaya Communication Manager Guide

Image 8

Contents MultiVOIP Configuration Guide Revision Date DescriptionContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameters screen Regional Parameter Definitions Field Name Values DescriptionRegional Parameter Definitions Field Name Values DescriptionTone Pair Values Communication Manager Settings Related MultiVOIP Setup ParametersRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Fax Enable Fax VolumeJitter Value Default = Mode Fax FRF 11 T.38Advanced Features Jitter Auto Disconnect AutomaticInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface FXO Interface Parameter Definitions Dialing OptionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options GK General Settings GK General Settings DefinitionsActivity Configuration PolicyGK General Settings Definitions cont’d RAS ParametersGatekeeper Endpoints Command Buttons Gatekeeper Calls Current Calls Field DefinitionsNumber. a sequential number for identification in the list ID alias of the endpoint originating the callCall Details Field Definitions Conference ID number CID is a unique non-zero value createdConference will have the same CID ID identifies the call with which the message is associatedTotal amount of bandwidth used by the call Type of conference request create, invite or joinLast reported state of the call Reason associated with the last state of the callH.323 alias name used to make the call E164 alias phone number used to make the callAn e-mail address used to make the call Address and port numberGatekeeper Network Parameters Network Parameter DefinitionsField Name Values Description Status Information OptionsARQ Line Hunting InformationCall Mode GK-ID Gatekeeper Services Services Screen DefinitionsField Name Values Description GK Defined Services PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV Rev MVP130-AV Rev aMVP130-AV-FXS Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones