Multi-Tech Systems 410, MVP103 manual Configuration

Page 22

Chapter 2 – Configuration

7e. To add an entry for an IP phone, configure Endpoint Type, Product ID, Names, Phones, and Security code fields as indicated below. Configure Phones and Security Code to match the values configured for this IP phone in Communication Manager. Leave the other fields blank. One entry is required for each IP phone located at the same site as this MultiVOIP. Do not create entries for IP phones located at other sites. They will not be able to register with this MultiVOIP in the event of a wan link failure. Click OK to save this entry. Repeat the above steps to add additional IP phone entries. The MVP210, MVP410, and MVP810 support 5,10, or 15 IP phones respectively.

The IP phones must be configured to use DHCP and the DHCP server must be located at the same site as the MultiVOIP and IP phones. This is the only means by which the IP phones are made aware of alternate gatekeepers, such as the MultiVOIP gatekeeper when the CM is unavailable due to WAN link failure.

Refer to the following Avaya documents for instructions on how to configure the DHCP server.

●4600 Series IP Telephone Lan Administrator’s Guide (Avaya document number 555-233-507). Read the section titled “DHCP” under “Server Administration”.

●Avaya one-x Deskphone Edition for 9600 Series IP Telephones Administrator’s Guide Release 1.5 (Avaya document number 16-300698). Read the section titled “DHCP and File Server” under “Server Administration”.

●Avaya one-x Deskphone Value Edition 1600 Series IP Telephones Administrator’s Guide Release 1.0 (Avaya document number 16-601443). Read the section titled “DHCP Server Administration”.

Your DHCP server must utilize site-specific options (SSON) #176 (46xx models) and/or #242 (16xx, 96xx models) which are IP Telephone-specific DHCP options specifying information such as TFTP server and Definity CLAN IP address. The MultiVOIP IP address must be listed at the end of the string. MCIPADD=xxx.xxx.xxx.xxx,yyy.yyy.yyy.yyy where xxx.xxx.xxx.xxx is one or more IP addresses used for Definity/CM CLAN IP boards and yyy.yyy.yyy.yyy is the MultiVOIP’s IP address.

22	Multi-Tech Systems, Inc. Avaya Communication Manager Guide

Image 22

Contents MultiVOIP Configuration Guide Revision Date DescriptionContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameters screen Regional Parameter Definitions Field Name Values DescriptionRegional Parameter Definitions Field Name Values DescriptionTone Pair Values Communication Manager Settings Related MultiVOIP Setup ParametersRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Jitter Value Default = Fax EnableFax Volume Mode Fax FRF 11 T.38Advanced Features Jitter Auto Disconnect AutomaticInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface FXO Interface Parameter Definitions Dialing OptionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options Activity Configuration GK General SettingsGK General Settings Definitions PolicyGK General Settings Definitions cont’d RAS ParametersGatekeeper Endpoints Command Buttons Number. a sequential number for identification in the list Gatekeeper CallsCurrent Calls Field Definitions ID alias of the endpoint originating the callConference will have the same CID Call Details Field DefinitionsConference ID number CID is a unique non-zero value created ID identifies the call with which the message is associatedLast reported state of the call Total amount of bandwidth used by the callType of conference request create, invite or join Reason associated with the last state of the callAn e-mail address used to make the call H.323 alias name used to make the callE164 alias phone number used to make the call Address and port numberField Name Values Description Status Information Gatekeeper Network ParametersNetwork Parameter Definitions OptionsARQ Line Hunting InformationCall Mode GK-ID Field Name Values Description GK Defined Services Gatekeeper ServicesServices Screen Definitions PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV-FXS Rev a MVP130-AV RevMVP130-AV Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones