Multi-Tech Systems 410, MVP103 manual Configuration

Page 18

Chapter 2 – Configuration

6b. Configure Call Signaling Port. Unlike station (FXS) ports, which require a unique value for each channel, trunk DID ports require that the same Call Signaling Port value be used on all DID trunk ports that are registered to the same Communication Manager PBX. Configure this to a unique value that is not being used by another station (FXS) or trunk (FXO) port on this MultiVOIP unit. This port value must fall within the range of port values supported by Communication Manager and should match the “Far-end Listen Port” value configured in the Communication Manager “Signaling Group” (“Display Signaling Group”) form (dialog box). All DID trunk ports on this MultiVOIP will use the same Signaling Group for communication with the CM Server.

Note that several other fields in the Communication Manager “Signaling Group” form (dialog box) must be set to accommodate operation with the MultiVOIP:

Group Type	= h.323

Remote Office?	= n

RRQ Required?	= y

Direct IP-IP Audio Connection?	= y

IP Audio Hairpinning?	= n

Calls Share IP Sig Connection	=y

6c. Configure Gateway Name. This should match the value configured for this MultiVOIP unit in the Communication Manager “IP Node Names” and “Signaling Group” forms.

6d. Configure Primary Gatekeeper IP Address. This must be configured to match the IP address of the

CLAN or PROCR card in the “IP Node Names” form of the primary Communication Manager Gatekeeper unit. Do not change the RAS Port and leave the Gatekeeper name field blank.

6e. Configure IP addresses for Alternate Gatekeeper1 and Alternate Gatekeeper 2 (optional). These must be configured to match the IP address of the respective CLAN or PROCR card in the PBX unit serving as the Alternate Gatekeeper. This field appears in IP Node Names form of the Communication Manager software for that PBX. If you are using the MultiVOIP Gatekeeper as an alternate gatekeeper, enter the IP address of the MultiVOIP. The alternate MultiVOIP gatekeeper must appear after any Communication Manager alternate gatekeepers.

18	Multi-Tech Systems, Inc. Avaya Communication Manager Guide

Image 18

Contents MultiVOIP Configuration Guide Revision Date DescriptionContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameters screen Regional Parameter Definitions Field Name Values DescriptionRegional Parameter Definitions Field Name Values DescriptionTone Pair Values Communication Manager Settings Related MultiVOIP Setup ParametersRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Jitter Value Default = Fax EnableFax Volume Mode Fax FRF 11 T.38Advanced Features Jitter Auto Disconnect AutomaticInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface FXO Interface Parameter Definitions Dialing OptionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options Activity Configuration GK General SettingsGK General Settings Definitions PolicyGK General Settings Definitions cont’d RAS ParametersGatekeeper Endpoints Command Buttons Number. a sequential number for identification in the list Gatekeeper CallsCurrent Calls Field Definitions ID alias of the endpoint originating the callConference will have the same CID Call Details Field DefinitionsConference ID number CID is a unique non-zero value created ID identifies the call with which the message is associatedLast reported state of the call Total amount of bandwidth used by the callType of conference request create, invite or join Reason associated with the last state of the callAn e-mail address used to make the call H.323 alias name used to make the callE164 alias phone number used to make the call Address and port numberField Name Values Description Status Information Gatekeeper Network ParametersNetwork Parameter Definitions OptionsARQ Line Hunting InformationCall Mode GK-ID Field Name Values Description GK Defined Services Gatekeeper ServicesServices Screen Definitions PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV-FXS Rev a MVP130-AV RevMVP130-AV Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones