Multi-Tech Systems MVP103, 410 manual Configuration

Page 13

Chapter 2 - Configuration

Note that, in page 2 of the Communication Manager “Station” form, the “Direct IP-IP Audio Connection” field must be set to “y” and the “IP Audio Hairpinning” field must be set to “n.”

4e. Configure Security Code. This must match the security code configured in the Communication Manager “Station” form (see first graphic in step 4d).

4f. Configure Primary Gatekeeper IP Address. This must be configured to match the IP address of the CLAN or PROCR card in the “IP Node Names” form of the primary CM gatekeeper. Do not change the RAS port from the default 1719 and leave the Gatekeeper Name field blank.

4g. Configure IP addresses for Alternate Gatekeeper 1 and Alternate Gatekeeper 2 (optional). These must be configured to match the IP address of the respective CLAN or PROCR card in the PBX unit serving as the Alternate Gatekeeper. This field appears in IP Node Names form of the Communication Manager software for that PBX. If you are using the MultiVOIP Gatekeeper as an alternate gatekeeper, enter the IP address of the MultiVOIP. The alternate MultiVOIP gatekeeper must appear after any Communication Manager alternate gatekeepers.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

13

Image 13

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Fax Volume Fax EnableJitter Value Default = Mode Fax FRF 11 T.38Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options GK General Settings Definitions GK General SettingsActivity Configuration PolicyRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons Current Calls Field Definitions Gatekeeper CallsNumber. a sequential number for identification in the list ID alias of the endpoint originating the callConference ID number CID is a unique non-zero value created Call Details Field DefinitionsConference will have the same CID ID identifies the call with which the message is associatedType of conference request create, invite or join Total amount of bandwidth used by the callLast reported state of the call Reason associated with the last state of the callE164 alias phone number used to make the call H.323 alias name used to make the callAn e-mail address used to make the call Address and port numberNetwork Parameter Definitions Gatekeeper Network ParametersField Name Values Description Status Information OptionsLine Hunting Information ARQCall Mode GK-ID Services Screen Definitions Gatekeeper ServicesField Name Values Description GK Defined Services PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV Rev a MVP130-AV RevMVP130-AV-FXS Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones