Multi-Tech Systems MVP103, 410 manual Miscellaneous

Page 65

Chapter 4 - Miscellaneous

Chapter 4 - Miscellaneous

Gateway Survivability Mode

A customer may wish to have some ports on the MultiVOIP gateway not be managed by CM, but rather have them directly routed over a private IP WAN to a second MultiVOIP gateway at the side of the WAN network. An example of this would be to send a T.38 fax call over the private IP WAN network to a fax port on a second MultiVOIP gateway.

Create phonebook entries for optional gateway survivable mode (if chosen). In this mode, the MultiVOIP provides survivability to local FXS/FXO ports; IP phones are not supported. If IP phone survivability is desired, it is recommended that you configure gatekeeper survivability in Section 6 and skip this section.

MultiVOIP Phonebook: A Communication Manager Example

1.An MVP810 (eight-channel) MultiVOIP is used

2.The MultiVOIP’s first six ports are used for analog stations with extensions numbers (6001-6006).

3.The MultiVOIP’s last two ports are used for analog FXO trunks that may be reached by dialing 9 plus the local area codes of “303” or “720”.

4.The IP address of this MVP810 is 204.26.122.1.

5.The incoming PSTN trunk calls from either port #7 or port #8 will use the “AutoCall” feature and will be routed to the first station port. This port will serve as an “attendant” during survivability. NOTE. Normally the “AutoCall” register will have the PBX extension of 8001 that will be forwarded up to the MultiVantage server. But in this example of survivable mode operation, the 8001 will be routed to local station port 6001 with the help of the Outbound Phonebook table.

6.The Q.931 Signaling Port value of each Outbound Phonebook entry must match the Call Signaling port value configured for the destination voice channel in the Communication Manager Settings screen. The MultiVOIP’s Outbound PhoneBook will be configured as illustrated in the table below.

MultiVOIP Phonebook: A Comm Mgr Example

Outbound	Remove	Add Prefix	IP Address
Destination	Prefix
Pattern
6001			204.26.122.1
6002			204.26.122.1
6003			204.26.122.1
6004			204.26.122.1
6005			204.26.122.1
6006			204.26.122.1
8001	8001	6001	204.26.122.1
9303			204.26.122.1
9720			204.26.122.1

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

65

Image 65

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Fax Volume Fax EnableJitter Value Default = Mode Fax FRF 11 T.38Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options GK General Settings Definitions GK General SettingsActivity Configuration PolicyRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons Current Calls Field Definitions Gatekeeper CallsNumber. a sequential number for identification in the list ID alias of the endpoint originating the callConference ID number CID is a unique non-zero value created Call Details Field DefinitionsConference will have the same CID ID identifies the call with which the message is associatedType of conference request create, invite or join Total amount of bandwidth used by the callLast reported state of the call Reason associated with the last state of the callE164 alias phone number used to make the call H.323 alias name used to make the callAn e-mail address used to make the call Address and port numberNetwork Parameter Definitions Gatekeeper Network ParametersField Name Values Description Status Information OptionsLine Hunting Information ARQCall Mode GK-ID Services Screen Definitions Gatekeeper ServicesField Name Values Description GK Defined Services PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV Rev a MVP130-AV RevMVP130-AV-FXS Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones