Multi-Tech Systems MVP103, 410 manual Voip Caller ID Case #4 Remote FXS call on H.323 voip system

Chapter 3 – Related MultiVOIP Setup Parameters

Call is received						CID Flow
here.			CID
		FXS	Terminating
			VoIP
					Network
	xxxyyyzzzz					IP
	J.Q. Public
			Clock:
			10/03, 4:51pm	H.323 Protocol*
Display shows:

CID Number: 423

CID Name: Anoka-Whse-VP3

Time Stamp: Date: 10/03

Time: 4:51pm

*In x.06 release, when SIP protocol is used, CID Name field will duplicate value in CID Number field.

CID						Call originates here
		Ch1	FXS				at 4:51pm, Oct 3.
Generating
		401
VoIP					xxxyyyzzzz
					J.Q. Public
	Ch2	402		phone of:				Nigel Thurston
	Ch3
		403						763-555-9401
	Ch4
		404

Phone Book Configuration

Gateway Name: Anoka-Whse-VP3

Q.931 Parameters	Inbound Phone Book {Channel 2}
	Remove Prefix Add Prefix Forward/Addr
Gatekeeper RAS Parameters
		423
		748

Figure 4: Voip Caller ID Case #4 – Remote FXS call on H.323 voip system

Call is received						CID Flow
here.			CID
		FXS	Terminating
			VoIP		Network
	xxxyyyzzzz					IP
	J.Q. Public
			Clock:
			11/15, 6:17pm
Display shows:				H.323 Protocol*

CID Number: 423

CID Name: Anoka-Whse-VP3

Time Stamp: Date: 11/15

Time: 6:17pm

*In x.06 release, when SIP protocol is used, CID Name field will duplicate value in CID Number field.

				Call originates here
CID				at	6:17pm, Nov 15.
Generating	Ch1	DID	Central Office
VoIP			without
Ch2			standard telephony
						J.Q. Public
						xxxyyyzzzz
Ch3			Caller ID service

		Ch4				phone of:
							Edwin Smith
							763-743-5873
Phone Book Configuration
Gateway Name:			Anoka-Whse-VP3
	Q.931 Parameters
				Inbound Phone Book {Channel 2}
				Remove Prefix		Add Prefix Forward/Addr
	Gatekeeper RAS Parameters
					423
					748

Figure 5: Voip Caller ID Case #5 – Call through telco central office without standard CID enters

DID channel in H.323 voip system

E&M Parameters. E&M is not supported if “Register with Communication Manager” is enabled.

DID Parameters. The parameters applicable to the Direct Inward Dial (DID) telephony interface type are shown in the figure below and described in the table that follows. The DID interface allows one phone line to direct incoming calls to any one of several extensions without a switchboard operator. Of course, one DID line can handle only one call at a time. The parameters described here pertain to the customer- premises side of the DID connection (DID-DPO, dial-pulse originating); the network side of the DID connection (DID-DPT, dial-pulse terminating) is not supported.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide 49