Multi-Tech Systems MVP103, 410 manual Configuration

Page 9

Chapter 2 - Configuration

using a non-Avaya analog telephone. This station must be properly administered in the Audix Voice Mail System for the message waiting feature to work.

2d. Activate the “Caller ID” feature if you have FXS Interface selected and are using an analog telephone with caller ID display. The MultiVOIP will output Caller ID information, if received, between the first and second rings.

2e. Activate “Caller ID” on FXO interfaces if the attached line supports it. The MultiVOIP will capture the Caller ID information, if provided, between the first and second rings and will forward the information to CM.

Note: If the CM customer is operating on CM release 2.0.1 (or newer), remember that for the ‘h323’ specified station, the following CM admin fields must be set appropriately:

a)The ‘Message Waiting’ field must be enabled and set to “led” if this feature is intended to be supported on the MultiVOIPs analog station port.

b)Similarly, the following features must be enabled as desired:

•Switchhook flash

•Call Waiting Indication

•Attendant Call Waiting Indication

Multi-Tech Systems, Inc. Avaya Communication Manager Guide

9

Image 9

Contents MultiVOIP Revision Date Description Configuration GuideContents Introduction IntroductionMultiVOIP in Avaya Communication Manager System Configuration ConfigurationChannel RTP Port Rtcp Port T38 Port Configuration Configuration Bandwidth per Channel Voice Frames per IP Packet Communication Manager MultiVOIP FXS Channels Configuration Configuration Communication Manager MultiVOIP FXO Channels Configuration = Isdn Communication Manager MultiVOIP did Channels Configuration = Isdn Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Configuration Regional Parameter Definitions Field Name Values Description Regional Parameters screenField Name Values Description Regional Parameter DefinitionsTone Pair Values Related MultiVOIP Setup Parameters Communication Manager SettingsRelated MultiVOIP Setup Parameters Version 4 Parameters Voice/Fax Parameters Channel to be configured is selected here Fax Volume Fax EnableJitter Value Default = Mode Fax FRF 11 T.38Advanced Features Jitter Automatic Auto DisconnectInterface Parameters Related MultiVOIP Setup Parameters FXS Not applicable to FXS interface Dialing Options FXO Interface Parameter DefinitionsFXO Disconnect On cont’d CID Number Voip Caller ID Case #4 Remote FXS call on H.323 voip system Did Options GK General Settings Definitions GK General SettingsActivity Configuration PolicyRAS Parameters GK General Settings Definitions cont’dGatekeeper Endpoints Command Buttons Current Calls Field Definitions Gatekeeper CallsNumber. a sequential number for identification in the list ID alias of the endpoint originating the callConference ID number CID is a unique non-zero value created Call Details Field DefinitionsConference will have the same CID ID identifies the call with which the message is associatedType of conference request create, invite or join Total amount of bandwidth used by the callLast reported state of the call Reason associated with the last state of the callE164 alias phone number used to make the call H.323 alias name used to make the callAn e-mail address used to make the call Address and port numberNetwork Parameter Definitions Gatekeeper Network ParametersField Name Values Description Status Information OptionsLine Hunting Information ARQCall Mode GK-ID Services Screen Definitions Gatekeeper ServicesField Name Values Description GK Defined Services PublicDynamic Miscellaneous MiscellaneousComm Mgr Dialing Example #1 a local station-to-station call Remote Configuration Miscellaneous MVP130-AV Rev a MVP130-AV RevMVP130-AV-FXS Rev a MVP210-AV Rev aMiscellaneous Link Management Feature Issues Index IndexCoder field FRF11 Gatekeeper Response to field GK General Settings, RAS DID-DPO FXO Trunk Group form fields to set Dtmf Gain Unregister endpoints command Dtmf Gain High Tones