Multi-Tech Systems 410, MVP103 manual Fxs

Chapter 3 – Related MultiVOIP Setup Parameters

FXS Loop Start Parameters. The parameters applicable to FXS Loop Start are shown in the figure below and described in the table that follows.

FXS Loop Start Interface: Parameter Definitions

Field Name	Values	Description
FXS (Loop	Y/N	Enables FXS Loop Start interface type.
Start)
Dialing Options fields
Inter Digit	1 - 10 seconds	This is the length of time that the MultiVOIP will wait between
Timer		digits. When the time expires, the MultiVOIP will place the call.
		Default = 2.
Message	--	If “Register with Communication is enabled”, this field enables
Waiting		message waiting indication on FXS channels. Choices are “Light” or
Indication		“Stutter Dial Tone”.
Inter Digit	in milliseconds	The length of time between the outputting of DTMF digits.
Regeneration		Default = 100 ms.
Time
Ring Count,	1-99	Maximum number of rings that the MultiVOIP will issue before
FXS		giving up the attempted call.
FXS Options,	Y/N	When enabled, the MultiVOIP will interrupt loop current in the FXS
Current Loss		circuit to initiate a disconnection. This tells the device connected to
		the FXS port to hang up. The Multi-VOIP cannot drop the call; the
		FXS device must go on hook.

44 Multi-Tech Systems, Inc. Avaya Communication Manager Guide