Wagner SprayTech HIGH PERFORMANCE AIRLESS SPRAYER owner manual Components and Assembly

COMPONENTS AND ASSEMBLY

COMPONENTS	CONTROLS AND FUNCTIONS
• Spray gun with filter	ON/OFF switch	.................The ON/OFF switch turns the unit on
• Spray tip assembly		and off (O = OFF, l = ON)
• 25 foot long, 1/4 inch diameter high pressure hose.	Spray Gun	The spray gun controls the delivery of
TOOLS NEEDED FOR ASSEMBLY		the fluid being pumped.
	Spray Hose	The spray hose connects the gun to
• Two adjustable wrenches.
		the pump.

•Extension cord (refer to Important Electrical Information

(page 3).		Return Tube .......................Fluid is sent back out through the return
		tube to the hopper when priming.
	WARNING	PRIME/SPRAY knob ........The PRIME/SPRAY knob directs fluid
		to the spray hose when set to SPRAY,
Do not plug in the unit until setup is complete.
		or the return tube when set to PRIME.
			ON/OFF Switch
		Inlet filter	= ON
		(inside of hopper)

Handle
					= OFF
			Hopper lid
Return
tube			Motor	PRIME/SPRAY
			housing
				knob
Hopper
			Rear
			handle
Frame			ON/OFF	PRIME	SPRAY
			switch
Outlet			Inlet valve
valve			tool	PRIME
Tip				position
storage			PRIME/SPRAY
			knob
Spray	Spray tip			SPRAY
gun	assembly
	Trigger lock			PRIME
	Trigger
		Tip	Tip
		guard	Spray	SPRAY
				position
			hose

ASSEMBLY

1

2

3

Place the handle over the unit frame. Insert the bolts and tighten the wing nuts over the lock washers.

Thread one end of the high pressure spray hose to the outlet valve. Tighten with an adjustable wrench. Attach return tube to hopper.

Thread the other end of the hose to the spray gun. Hold the gun with one adjustable wrench, and tighten the hose nut with the other.

English Customer Service: 800-328-8251 4 © 2003 Wagner Spray Tech - All rights reserved.