Friedrich YS09 operation manual Section a a

920-198-01

STEP 11 INSTALL THE SIDE WINGBOARD PANELS – Be sure the cabinet has been secured to the window sill and that the out- side support brackets have been installed as shown in Figure D. Raise the window sash and install the right and left side wingboard panels. (See Figure G).

STEP 12 INSTALL THE WINDOW SEALING GASKETS – Measure and cut the vinyl window seal gasket (grey color, Item # 12) to ¿t the width of the window, and install as shown in Figure H. Pull the window sash down behind the gasket. Measure and cut the dark foam window seal gasket (Item #13) and install it between the upper glass panel and the top part of the lower sash. (See Figure H).

NOTE: FOR REASONS OF SECURITY AND SAFETY, THE CUSTOMER MUST PROVIDE A MEANS OF PREVENTING THE WINDOW FROM OPENING.

STEP 13 When possible, caulk the outside of the installation with industrial type caulking to prevent weather leaks.

CAUTION

Excessive Weight Hazard

Use two or more people when installing your air conditioner.

Failure to do so can result in back or other injury.

Figure G

SECURE THE SIDE WINGBOARD PANELS TO

THE SIDE ANGLES WITH FOUR (4) #8 x ½" LONG

SCREWS (ITEM #11), TWO ON EACH SIDE.

TOP OF CABINET

PLACE WINGBOARD PANEL IN

WINDOW JAM TO COMPRESS THE

SPRINGS INSIDE THE RUNNERS,

AND SWING THE PANEL INTO PLACE

INDICATED BY THE DOTTED LINE.

WINDOW JAM

SECTION A - A

CAUTION

Cut/Sever

Although great care has been taken to minimize sharp edges in the construction of your unit, use gloves or other hand protection when handling unit.

Failure to do so can result in minor to moderate personal injury.

STEP 14 INSTALL CHASSIS – After installing the shell, slide the chassis into the shell stopping approximately 3" from full insertion. Stuff the chassis seal gasket one inch deep between the chassis and the shell (see Figure I). Begin at either bottom corner and go up the side, across the top, and down the opposite side. Then push the chassis all the way into the shell for the remaining distance so that the plastic front meets the front edge of the shell.

If chassis seal gasket is not installed, the operation of the unit will be negatively affected. Operational noise and outside noise will also be ampli¿ed.

STEP 15 Reattach the chassis retainer wire with the same screw as in Step 3 (See Figure A).

Figure H

INSERT VINYL WINDOW SEAL
GASKET OVER TOP ANGLE	INSERT FOAM WINDOW
TO WINGBOARD (ITEM #12)	SEAL GASKET (ITEM # 13)

	LOWER WINDOW SASH
VINYL	TOP WINGBOARD ANGLE
WINDOW
GASKET

SECTION B - B

13