Friedrich YS09 operation manual Figure J

920-198-01

STEP 16 OPTIONAL: The factory assembles the supply cord so that it exits the left side of the unit. At the consumer’s discretion, the supply cord can be made to exit the right side of the unit. To do this, remove the black rubber coated cord clamp from under the far left screw (See Figure I). Replace this screw back into the far left screw hole. Route the supply cord over the top of the return air grille latches and reattach the clamp to the adjacent screw hole (Figures I & J). Detach the right side cord clamp, route the supply cord through it and reattach. The supply cord should be pulled taut so as not to rest on the return air grille latches.

Figure I

FAR

LEFT

SCREW

ADJACENT

SCREW

HOLE

CHASSIS

SEAL

GASKET

WHEN INSTALLING CHASSIS SEAL GASKET,

BEGIN AT EITHER BOTTOM CORNER AND

GO UP THE SIDE, ACROSS THE TOP, AND

DOWN THE OPPOSITE SIDE.

STEP 17 Be sure the ¿lter is in place before installing the return air grille (See Figure J), and that the electrical cord is properly routed so not to interfere with the installation. (See Step 16.)

STEP 18 Pick up the grille by supporting it from both sides near the bottom (See Figure K, Note 1.) Lift return air grille and insert the grille's tabs into the bottom slots of the discharge plenum (See Figure K, Note 2). Snap the grille into place by pushing the grille up and onto the unit's latches at the bottom (See Figure K, Notes 3 and 4).

STEP 19 Refer to the Operating Instructions beginning on page 3.

Figure J

ADJACENT

SCREW HOLE

AIR FILTER

CORD

CLAMP

RETURNAIR

GRILLE LATCH

RETURNAIR

GRILLE LATCH

CORD CLAMP

Figure K

DISCHARGE	NOTE 2
AIR PLENUM
	SLOT
SLOT

TAB	TAB	RETURN
		AIR
	RETURN	GRILLE
NOTE 1
	AIR GRILLE
	(NOTE 1)	LATCH
NOTE 3	NOTE 3	NOTE 4
		SIDE VIEW
	LATCHES

14