Panasonic EY7411  Bit-locking Function,  Speed Selector Switch,  Main Switch Lock

●The light will automatically turn off if the drill is not used for 5 minutes.

●The light uses an extremely small amount of current. Using the light has a negligible effect on the operational capacity of the drill.

●The LED is incapable of lighting the tip of the bit when the drill is used in the straight configuration.

Bit-locking Function

With the switch at off and the bit lock­ ed in place, the tool can be used as a manual screw-driver - up to 14.7 N·m (150 kgf-cm, 130 in-lbs).

There will be a little play in the driving shaft, but this is not a malfunction.

Forward

Forward

Reverse

Reverse

Speed Selector Switch

To suit the application of this tool, two different rotational speeds are avail- able. Depending upon use, either the high or low speed should be select- ed.

HIGHLOW

	Speed selection		Torque
LOW	200 min-1	(rpm)	High
HIGH	600 min-1	(rpm)	Low

CAUTION:

•Check speed selector switch before use.

•Do not operate the speed selector switch while the main switch is on (switch is in the ON position).

Main Switch Lock

After use, set the main switch lock at the lock position to prevent accidental operation.

Main switch lock Lock

Main Switch (ON/OFF)

Push the upper half of the switch for forward rotation, or the lower half for reverse rotation.

Battery Pack (EY9L10)

CAUTION:

1.Remove the battery pack away from the tool.

2.Charge the battery pack using the battery charger.

- 11 -