Cisco Systems 2140, 2130 manual Stripping the Ground Wire

Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance

Cisco ADE 2130 and 2140 Series Appliance Power

Figure 3-10 Stripping the Ground Wire

0.5 in. (12.7 mm) ± 0.02 in. (0.5 mm)

Insulation

Wire lead

60528

Step 5 Slide the open end of a single 90° standard barrel, two-hole ground lug with 5/8-inch pitch over the exposed area of the 10-AWG wire.

Step 6 Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the 10-AWG wire. (See Figure 3-11.)

Figure 3-11 Crimping a Ground Lug onto the Ground Wire

60529

Step 7 Use the two nuts that were installed on the ground studs to attach the ground lug and wire assembly to the two ground studs on the rear of the appliance.

Step 8 Use a torque wrench to tighten each nut to 10 in-lb (1.12 N-m) torque.

Step 9 Connect the other end of the ground wire to a suitable grounding point at your site.

Proceed to the next section,“Power Connections,” to continue the installation.

Power Connections

To ensure the appliance chassis power connection is adequate, you will need the following parts and tools:

•18-AWG copper wire for the power cord

•Wire-stripping tool for stripping the 18-AWG copper wire

•Number 2 Phillips screwdriver

Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide

78-18579-02 3-15