Setting Spindle Speed Range
The high/low range lever shown in Figure 47, is used to select one of the two spindle speed ranges.
High/Low
Range Lever
Figure 47. High/low range lever set to low.
When the lever is moved to the right, as shown in Figure 47, the low spindle speed range (100–1000 RPM) is selected. When the lever is moved to the left, the high spindle speed range (100–2000) RPM is selected.
Setting Spindle Direction & Speed
Set the spindle rotation direction to forward or reverse with the spindle direction switch, shown in Figure 48. Reset the Emergency Stop button, press the ON button, then turn the variable speed dial clockwise until the desired spindle speed dis- plays on the spindle speed display.
| Emergency Stop |
Variable | Button |
| |
Speed |
|
Dial |
|
| Spindle |
| Speed |
| Display |
| Spindle |
| Direction |
| Switch |
Figure 48. Spindle speed and direction controls.
Configuration Example
Follow this example to gain a better understand- ing of how to set the spindle speed.
To set spindle speed to 100 RPM:
1.Make sure spindle is completely stopped, and shift high/low range lever to LOW, as shown in Figure 47.
Note: If high/low range lever does not eas- ily adjust into position, rotate chuck by hand while you apply pressure to lever. When gears align, the lever will easily move into place.
2.Turn variable speed dial to "0".
3.Turn spindle direction switch to "F", and press ON button.
4.Adjust variable speed dial until spindle speed display reads 100 RPM.
Model G0765 (Mfd. Since 12/13)