STAND ASSEMBLY
1.The stand legs have protrusions which align with the holes in the top and bottom brackets. Assemble the stand as shown in Fig. 9A, using 16 carriage bolts and hex lock nuts. Do not completely tighten the hardware at this time.
IMPORTANT: THE TOP, FRONT, AND REAR BRACKETS (A&B) FIG. 9A, ARE LONGER THAN THE TOP SIDE BRACKETS (E) FIG. 9A. THE BOTTOM FRONT AND REAR BRACKETS (D) FIG. 9A, ARE LONGER THAN THE BOTTOM SIDE BRACKETS (C).
2.Assemble the rubber feet (F) Fig. 9A. NOTE: Each rubber foot is provided with holes for mounting the stand to the floor surface if required.
ATTACHING DUST BAG
1.Attach the dust bag to the bag frame and place the frame of the dust bag inside the saw stand as shown in Fig. 9B. Refer to the section below to attach this assembly to the saw.
SAW TO STAND
1.Turn saw table face down on a piece of cardboard to protect the table surface. Place stand upside down onto saw and align the four holes in the stand with the mounting holes in the saw.
2.Using the 2 longer screws for the front, place a M8 flat washer on a M8X1.25X45mm hex head screw. Insert the hex head screw through the mounting hole in the saw and the mounting hole in the stand. Place another M8 flat washer on the hex screw and thread a M8X1.25 hex nut on the screw and loosely tighten. Repeat this process to complete another hole in the saw front.
Using the 2 shorter screws for the back, place a M8 flat washer on a M8X1.25X30mm hex head screw in the back of saw. Insert the hex head screw through the mounting hole in the saw and the mounting hole in the stand. Place another M8 flat washer on the hex screw and thread a M8X1.25 hex nut on the screw and loosely tighten. Repeat this process to complete another hole in the saw back.
3.Then, turn saw table face up, as shown in Fig. 9C (Saw is shown fully assembled here).
4.Push down on top of the saw so the legs of the stand adjust to the surface of the floor and tighten all stand hardware and hardware which secures saw to stand.
EB D
E
CA
D C
F
Fig. 9A
Fig. 9B
Fig. 9C
11