HOW TO ATTACH THE TOOL AND CHISEL HOLDER
1.Attach the tool and chisel holder (A) Fig. 8 to the back of the column, using the two M6x1x12mm screws (B) and M6 flat washers.
2.Fig. 9 illustrates the stored chuck key/wrench (C), bushing (F) for use with extra long chisels, and chisels and bits (E).
B 
A
B 
Fig. 8
E
C
F 
A 
Fig. 9
HOW TO FASTEN THE MACHINE TO A SUPPORTING SURFACE
If the machine has any tendency to tip over, slide, or walk on the supporting surface, you must secure the base of the machine to a supporting surface with fasteners (not supplied) through the two holes (A) Fig. 10, located in the Mortiser base.
A |
Fig. 10 |
HOW TO ATTACH THE CHISEL AND BIT
Disconnect the machine from the power source!
1. Insert the bit (A) Fig. 11 in the chisel (B).
NOTE: The opening (C) on the side of the chisel (that allows chips to escape) should always face the side - never the front or rear.
A
B
C
Fig. 11
8