Kompernass PET 23 VARIO manual Commissioning, Loading the magazine, Switching on and off

Commissioning

The following information shall be considered as recommendatory only. Determine for yourself by practical tests the best staple or nail type and the optimum impact force setting for your substrate.

Recommended impact force setting for:

Staple /	Length	(mm)	Hardwood	Softwood	Chipboard /	Plywood
nail type			(e.g. oak or beech)	(e.g. spruce or pine)	MDF board	(e.g. wood core plywood)
11,4 mm
L	12		5 - 6	1 - 4	4 - 6	5 - 6
	14		6	2 - 5	5 - 6	6
10 mm	18		6 - 7	4 - 6	6 - 7	6 - 7
Type 53
6 mm	12		5 - 6	3 - 5	2 - 5	2 - 5
L	14		5 - 6	3 - 5	3 - 5	3 - 5
	16		6 - 7	5	4 - 5	4 - 5
4 mm	18		7	5	4 - 6	4 - 6
Type 55	19		7	6	5 - 7	5 - 7
L	23		7	6	6 - 7	6 - 7
Type 47

QLoading the magazine

Use only fine wire staples (type 53), narrow-backed staples (type 55) or nails (type 47)!

jPress the magazine slider 7 in the direction of the magazine 5 and guide it upwards.

jPull the magazine slider 7 completely out of the magazine 5 .

jIf necessary remove any staples or nails of the wrong type from the magazine 5 .

jSlide the correct staples or nails into the maga- zine 5 .

jLook at the depiction on the magazine slider 7 for how to insert the staples or nails correctly.

jPush the magazine slider 7 into the magazine 5 until it meets the stop.

jThen press the magazine slider 7 downwards until it has definitely engaged.

QSwitching on and off

mCaution! Connect the tool to the mains only when it is switched off. To do this set the On /  off switch 8 to position “0”.

To switch on:

jSet the On / off switch 8 to position “I” (see Fig. A).

10 GB