Delta 37-071 instruction manual To Calibrate the 45 Inward and Outward Stops, Depth Adjustment

OPERATION

TO CALIBRATE THE 45° INWARD AND OUTWARD STOPS:

1.Loosen the beveling lock by rotating the handle counterclockwise.

2.Refer to Figure 18 and locate the two sets of 45° Stop Bolts (A), there are two bolts that set the position for the inward 45° Stop and two that set the position for the outward 45° stop.

3.Loosen the two retaining nuts on the appropriate set of Stop bolts and adjust the Stop bolts either in or out.

NOTE: The heads of both Stop bolts must be flush against the mount assembly.

4.Re-tighten the retaining nut and re-lock the beveling lock. Then re-check the angle using the carpenter’s square. Continue to adjust as needed.

FIGURE 18

DEPTH ADJUSTMENT

Disconnect the machine from the power source before making any adjustments!

The DELTA® 37-071 Bench Jointer is designed to remove no more than 1/8” of stock in a single pass. For operations requiring the removal of more stock, make several passes to achieve the desired dimensions.

1.To adjust the depth of cut, rotate the infeed table height adjustment wheel. Turning the wheel clockwise raises the table (reducing the depth of cut) while rotating it counterclockwise lowers the table (increasing the depth of cut).

15