Brush Change, Base Maintenance | DeWalt DW735X instruction

English

MAINTENANCE

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories.

Brush Change	U

Your planer is equipped with brush caps

(U) that are external to the motor. If your brushes need to be replaced, begin by acquiring a new set from a DEWALT service center or a dealer authorized to service DEWALT products. Use only identical DEWALT brushes.

TO REPLACE THE BRUSHES ON YOUR PLANER

1.	Use the T-wrench to remove the
	top cover and brush cover screen on the
	planer.
2.	Use a flathead screwdriver to unscrew
	the brush cap located in the right, rear of
	the unit (V).	V
3.	Do the same for the brush cap located	V
3.	Do the same for the brush cap located

on the side of the motor, inside the planer cover.

4.Place the new brushes into the brush holders.

5.After installing the brushes, replace the top cover and brush cover screen.

6.Before using the planer, run the unit for 10 minutes to seat new brushes.

NOTE: If existing brushes do not need replacing, be sure to maintain the same orientation when you reinstall them.

Calibrating the Depth Adjustment Scale

	The depth adjustment scale (N) on your planer is set at the factory.
	However, with extended use, the depth adjustment scale could show
	an incorrect measurement.
	To check the depth adjustment scale,
	plane a piece of scrap wood, noting
	the measurement on the depth
	adjustment scale.	W
	Measure the finished thickness of	W
	the workpiece. If the thickness of the	N
	workpiece does not match the reading	N
	workpiece does not match the reading
	on the depth adjustment scale, loosen
	the two screws (W) on the red indicator.
	Adjust the pointer up or down until its
	reading matches the finished thickness
	of the workpiece. Securely re-tighten
	the screws.

Base Maintenance

Keep the table clean and free from oil, grease, and pitch. Treat the table with paste wax to help maintain its smooth finish.

Circuit Breaker Reset Button

Your planer is equipped with an 18 amp	X
circuit breaker. If your planer becomes
overloaded and stops operating, turn off the
planer, let the unit sit for 2 minutes and press
the reset button (X) before you resume
working.

WARNING: To prevent the planer from

starting unexpectedly if power is interrupted by

a circuit breaker trip, make sure the switch is in the OFF position before restoring power.