Repairs, Three Year Limited Warranty

English

WARNING: The planer could tilt or fall from the table if it is not properly secured opposite the end where the folding table is being installed. Serious injury may result.

3.Place the spring onto the small end of the stepped bolt.

4.Insert the end of the bolt with the spring around it into the larger hole on the side of the base.

5.Push the stepped bolt all the way through the hole in the first rib on the underside of the planer. The spring should engage the rib slightly and the threads should show on the right side of the rib.

	6. On the underside of the planer,	FIG. 7
	use a wrench to hold the nut in	FIG. 7
	use a wrench to hold the nut in
	place while turning the stepped
	bolt into it. The T-wrench on your
	planer can be used to turn the
	stepped bolt until it is fully secured
	(Fig. 7).
	7. Install the smaller screw into the
	lower threaded hole on the side
	of the base. Use the T-wrench
	to tighten that fastener securely
	(Fig. 8).

FIG. 8

FIG. 9

8.Depress the top pin until it is flush with the base and slide the top hole of the table over the pin and release the pin so they lock together (Fig. 8, 9).

9.To attach the table to the rear of the planer, install the bolts and spring following the above procedure.

Your tables should now fold up and down on the top screw and rest on the bottom screw while in position for planing.

NOTE: To transport the planer with the tables, fold them up and carry the unit as recommended by the planer manual.

WARNING: For your own safety, it is recommended that two people carry this machine or serious injury could result.

TO REMOVE THE TABLES

1.Depress the spring-loaded bolts on the base and slide each end of the table toward you so they disengage the holes in the tables. You may want to use the T-wrench from your planer to push the bolts flush with the base to easily remove the tables.

2.Leave the hardware (stepped bolts and small cap screw) in the base until you need to re-attach the tables.

Repairs

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service personnel. Always use identical replacement parts.

Three Year Limited Warranty

DEWALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date of purchase. This warranty does not cover part failure due to normal wear or tool abuse. For further detail of warranty coverage and warranty repair information, visit www.dewalt.com or call 1-800-4-DEWALT (1-800-