NOTE: Circuit breaker overload is often the result of dull knives. Change your knives on a regular basis to avoid tripping your breaker. Check your knives before
See the Troubleshooting Guide on page 14 for additional information on circuit breaker trips.
Replacing the Drive Belt
Drive belts are available at extra cost at DEWALT authorized service centers. Replacement of the drive belt should be performed by qualified service personnel.
Chip Ejection Fan
The chip ejection fan on your planer should be cleaned or cleared of debris periodically.
NOTE: TURN OFF AND UNPLUG THE PLANER PRIOR TO ACCESSING THE CHIP EJECTION FAN.
TO ACCESS THE FAN
1.Remove the top cover of the planer with the
2.Remove the dust shroud (Fig. 2, 3) and place it aside.
3.Remove the screws around the fan housing.
4.Remove the fan housing and place it aside as shown. The fan will now be exposed for cleaning.
See the Troubleshooting Guide, page 14, for additional information.
WARNING: Be sure to properly attach the fan housing and assemble the shroud and top cover correctly before using your planer again.
Accessories
WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of
injury, only DEWALT, recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost from your distributor or local service center.
Four accessories are available for the DW735 Thickness Planer.
•DW7350 Mobile Stand
•DW7351 Folding Tables
•DW7352 13" Knives
•DW7353 Chip Ejection Accessory
If you need any assistance in locating these accessories, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 or call
DW7351 Accessory Folding Tables
WARNING: For your own safety, read the tool instruction manual before attaching the tables. Failure to heed these warnings may result in personal injury and serious damage to the planer and the accessory. When servicing this tool, use only identical replacement parts. Have damaged cords replaced by an authorized service center.
Your DW7351 folding table box should include:
2 | folding tables | 4 | cap screws |
4 | springs | 4 | nuts |
4 | stepped bolts |
|
|
SET-UP AND INSTALLATION OF BASE
HARDWARE
1.Place planer on a secure table or workbench. Position planer so the front
2.Secure the rear of the planer to the table/bench with nails or screws to prevent it from tilting or falling from the table.
11